• Tuck the orange wire inside the junction box. It is used for interconnect only. INTERCONNECTED UNITS ONLY: Strip off about 1/2” (12 mm) of the plastic coating on the orange wire on the power connector. • Connect the white wire on the power connector to the neutral wire in the junction box. • Connect the black wire on the power connector to the hot wire in the junction box. • Connect the orange wire on the power connector to the interconnect wire in the junction box. Repeat for each unit you ar

2. Immerse the reagent pads into water sample for 2 seconds, remove, after 1 minute match colors to chart below. Total Nitrate/Nitrite (as N) (end pad) 3. Colors are stable for 1 minute. 0 0.5 2.0 5.0 Nitrite (as N) (pad nearest handle) 10 20 50 ppm 0 0.15 0.3 1.0 1.5 3.0 10 ppm pH / hardness / chlorine test instructions 1. Carefully open pH / Hardness / Chlorine Test packet and take out test strip. 2. Immerse the reagent pads into water sample immediately. Hold the strip level for 15 seconds. 3

However, if the CO Alarm • This unit does not work without power. If the AC power fails, the (usually white) in the junction box. (OSHA) requirements for carbon monoxide detectors must be met. is installed outside the bedroom, it may not wake up a sound sleeper or one battery back-up will power the alarm for at least 7 days provided • Connect the black wire on the power connector to the hot wire (usually who has recently used drugs or has been drinking alcoholic beverages. This CO alarms may not

Both models are approved for use in recreational vehicles. CAT. FG225B/FG250B FRONT SIDE Back VIEW VIEW View 4.25” 1.6” ARCHITECTURAL AND ENGINEERING SPEC 1. A dual ionization sensing chamber. 2. The unit shall be capable of self restoring. 3. A fully screened sensing chamber to resist entry of small insects thereby reducing the probability of unwanted alarms. 4. Powered by a supervised 9V battery and a solid state piezo horn rated at 85dB at 10 ft. 5. A visual LED power-on indicator to confirm

If you are installing this CO Alarm for use by others, you must leave this manual —or a copy of it—with the end user. M08-0217-000 P 04/09 Printed in Mexico BATTERY POWERED CARBON MONOXIDE ALARM USER’S MANUAL LISTED TO UL 2034 STANDARD Model CO250 IMPORTANT! PLEASE READ CAREFULLY AND SAVE. This user’s manual contains important information about your Carbon Monoxide Alarm’s operation. If you are installing this CO Alarm for use by others, you must leave this manual —or a copy of it—with the end u

It cannot prevent Smoke Alarms have played a key role in reducing deaths resulting from home will install this unit at the circuit breaker or fuse box before beginning To Avoid For Smoke Alarms” for details. Take short, shallow breaths. the Smoke Alarm be placed as far from these fuel-burning sources as or extinguish fires. Interconnect units within a single family residence only. Otherwise all house- fires worldwide. However, like any warning device, Smoke Alarms can only installation. Failure

The RM4 Relay is intended for use with BRK and First Alert Smoke, Heat and Carbon Monoxide Alarms. The relay contacts will activate whenever any interconnected alarm sounds. The relay contacts will automatically deactivate a few seconds after the alarm stops sounding. The RM4 may be wired next to an AC alarm or from a remote location. This relay must be installed in a junction box. Interconnects smoke alarms, carbon monoxide alarms and heat alarms with: • Lights • Bells • Door Closers • Sir

Test button should check all alarm functions by simulating a carbon monoxide condition, causing the unit to alarm. The silence feature is to temporarily silence unwanted alarms. 8. The unit shall be capable of operating between 40° F (4° C) and 100° F (38° C) and relative humidity between 10% and 90%. 9. The unit will alarm at the following CO levels: 70 PPM between 60 and 240 minutes; 150 PPM between 10 and 50 minutes; 400 PPM between 4 and 15 minutes. 10. The unit shall include mounting har

Allows for greater temperature and humidity range variations and more accurate digital display readings (C0410B). mm Allows easy battery replacement. SILENCE/ Single button tests alarm functions or silences unwanted alarms. 7TH ^ 11 *] m i m DISPLAY (€041 OB) Identifies CO hazard, stores, recalls and displays highest level of CO detected Illuminates only when button is pressed or unit is alarming. 2 AA Battery Powered Description: The First Alert Cat. Nos. C0400B and C041 OB are batter

HOW TO OPERATE YOUR FIRE EXTINGUISHER IN A FIRE EMERGENCY • Make sure your extinguisher may be safely and effectively used on the small fire you want to fight. Always use extreme caution when fighting any fire. Fight a fire only where there is a clear escape path to allow you to get out safely if the fire gets worse. • Avoid breathing smoke and heated fumes; stay low if necessary. Burning materials will release toxic fumes. Inhaling these fumes may cause injury or death. • Always stand back far