Release the lever and the seat will lock in that position. Under the right side of the seat there is a spring loaded red lever. Pulling up on the lever allows the seat to swivel, when released the seat will lock into one of four positions. Seat Slide Lever Swivel Seat Adjustment Lever Figure 6 Seat Removal (Fig. 7) Fold down the back of the seat. Pull up the red swivel seat adjustment lever (fig. 6) and lift seat off. Remove the hand knob and locking pin that secures the seat adaptor. Lift the s

Note: The controller can be fitted to suit either right or left-handed users. Please contact your provider for further assistance. 4/27/2006 10 The Joystick Controller (VR2) Shoprider HD (888 WHD) 1. On-Off Button: This button turns the joystick controller (hereinafter referred to as VR2) on and off. Do not use this button to stop the power chair, except in an emergency 2. Battery Gauge: This is a 10segment display, which indicates if the VR2 is switched on and gives the state of charge of the b

9) On the underside of the seat there are two hand knobs, one on each side. Loosening the arm rest tightening knob allows the armrest width to be adjusted or arm rests to be removed. Armrest Angle Adjustment (Fig. 10) Flip up the armrests to allow access to the adjustment screw and lock nut, unscrew the lock nut and screw the bolt in or out to increase or decrease the angle. Re-tighten the lock-nut. Your scooter is dispatched from the factory with the armrests set parallel to the floor. Scooter

23. Avoid turning sharply on a slope or gradient. 24. To brake in an emergency simply release the joystick. 25. Always try to find a “dropped curb” or “curb cutout” whenever possible. 26. Always keep your folding power chair properly maintained. 27. Never try to use your folding power chair beyond it’s limitations as described in this manual. Important Notes The FPC-11 power chair is designed to assist in your individual mobility needs. Any usage outside of the guidelines in this manual may resu

Use the arm rest for support if necessary. • Adjust the tiller and seat as previously described. Starting Scooter Movement • Ensure that you are seated in a comfortable position. • Turn the key to the on position. • Your speed setting should be on or near the turtle (slow). • Push your right thumb lever (yellow) and the scooter will move forward slowly. The harder you push, the faster the scooter goes but will only reach the speed level that has been selected. • Release the lever and the scooter

It is possible to unintentionally bring high levels of EM energy very close to the Powerchair’s control system while using these devices. This can affect the Powerchair’s movement and braking. Therefore, the warnings listed below are recommended to prevent possible interference with the control system of the Powerchair. WARNINGS The following warnings listed below should reduce the chance of unintended brake release or Powerchair movement, which could result in serious injury. 1. Do not operate

GolfRider™ Recreational Scooter Model: GR889 User Manual Pictured golf bag and golf clubs not included 12/2/2004 Table of Contents INTRODUCTION……….……………………………………………………………………3 3 FEATURE GUIDE………….………………………………………………………………..3 3 SAFETY ADVICE……….…………………………………………………………………...4 4 EMI WARNING……………….……………………………………………………………...5 5 WARNINGS……………….………………………………………………………………….6 6 ADJUSTMENTS……………………………………………………………………………..7 7 SCOOTER TILLER CONTROLS…………………………………………………………..9 8 DRIVE/FREEWHEEL OPERATION……...………………

Push the joystick in the direction you want to go. The further you push it, the faster the speed will be. Releasing the joystick will automatically engage the brakes and stop the Powerchair. 8. Charging Port: This is the primary charging port for the 6Runner. When using this charging port only plug into this port with the qualified Shoprider charger certified by the original manufacturer of the Powerchair. This port should not be used as a power supply for any other electrical devices. Doing eit

The maximum speed/profile indicator will be rippling up and down. • Push the joystick forward until the controller bleeps. • Push the joystick in reverse until the controller bleeps. • Release the joystick, there will be a long bleep. • The Powerchair is now unlocked. SLEEP MODE: If the controller is left on and not used for more than ten minutes, the controller will automatically “go to sleep”. This is recognized by a slow intermittent flash of the battery indicator lights. Simply turn the cont

Our designated maximum climbing height for this device is 63.5 mm/ 2.5 inches. To safely mount a curb, please follow the instruction below: STEP 1 Set the Maximum Speed Indicator at 3 (recommended) by adjusting the Speed Increase / Decrease Button (Fig.14). STEP 2 Approach the curb from a comfortable distance, and push the joystick all the way forward. Fig. 8a ~12~ GMP ISO9001 ISO14001 ISO13485 CERTIFIED PREPARATION FOR USE NOTE: Before using the Powerchair for the first time, be sure the batter