Indicator lights Salt 1) Comes on when the special salt has run out. Rinse aid 1) Comes on when the rinse aid has run out. Indicator lights Multi tab Indicates the activation/ deactivation of the Multi tab function (See 'Multi tab function'). 1) The salt and rinse aid indicator lights are never on while a washing programme is running even if filling with salt and/or rinse aid is necessary. 7 The digital display The digital display indicates: • The level of hardness to which the water softener is

• Remove the laundry immediately after the programme has finished. • Use a fabric conditioning sheet to reduce static. We recommend the sheet is pinned to an article of laundry (using a safety pin). • Mix the load i.e. large and small articles. • When drying large items such as sheets, we recommend you periodically stop the dryer to redistribute the load. DO NOT use the tumble dryer to dry the following: • Articles contaminated with inflammable substances e.g. petrol, cleaning solvents, cooking

These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. If you are unsure of the meanings of the these warnings contact the John Lewis branch from which you purchased the appliance. Installation • This appliance is heavy. Care should be taken when moving it. • It is dangerous to alter the specifications or attempt to modify this product in any way. • Any electrical work required to install this appliance should be carrie

The start of the programme or the countdown of the delay start will occur only after the closure of the door. Until then it is possible to modify the settings. 1. Check that the baskets have been loaded correctly and that the spray arms are free to rotate. 2. Check that the water tap is opened. 3. Press the On/Off button. The dishwasher must be in setting mode. 4. Press one of the two programme buttons to select a washing programme. When a programme is selected the corresponding programme light

A minimum water pressure of 0.5 bar is required for safe operation of the appliance. If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum vertical distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank. Water drainage This appliance is designed to be permanently plumbed into your home's drainage system using one of the following

These warnings have been provided in the interest of safety. You MUST read them carefully before use or installation by a qualified person. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance. Installation • This hob must be installed by qualified and competent personnel to the relevant National Standards. • Refer to Installation Information in chapter “Installation”. • Remove all packaging, both inside and outside the hob, bef

2 1 Telescopic Chimney comprising: 2.1 1 Upper section 2.2 1 Lower section 9 1 o150-120 Ducting spigot 10 1 o120-125 Ducting flange 15 1 Air outlet connector Ref Qty Installation Components 7.1 2 Hood body fixing brackets 7.2.1 2 Upper chimney wall fixing brackets 12c 6 Chimney fixing screws 12d 2 Screws M4x25 Ref Qty Documentation 1 Instruction booklet Installing the Cooker Hood Fitting the Wall Brackets • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical,

2. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. If y

These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensu

These warnings have been provided in the interest of safety .You MUST read them carefully before use or installation by a qualified person. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance. Installation • Any installation work must be undertaken by a qualified and competent person to the relevant National Standards. • This hood must be installed in accordance with the installation instructions and all measurements must be ad