Next, open the needle valves fully and check for bubbles at control valve, along the entire length of hose and at the SAE fitting. DO NOT LEAVE GAS ON FOR MORE THAN 10 SECONDS. If soapy mixture starts bubbling, gas is leaking through the connection or hose. Turn the propane tank valve OFF and retighten the connection that is leaking gas. Repeat procedure with soapy mixture until gas no longer leaks. NEVER USE A FLAME TO CHECK FOR GAS LEAKS. Turn the propane tank valve OFF after each test. 5. Onc

IMPORTANT SAFETY WARNINGS WE WANT YOU TO ASSEMBLE AND USE YOUR SMOKER AS SAFELY AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR SMOKER. WHEN YOU SEE THE SAFETY ALERT SYMBOL, PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR SMOKER. WARNING • • • • • • • • • • • • • • • • • • • • Use smoker only on a hard, level, noncombust

For stubborn food residue, use a degreaser and fiber or brass cleaning brush. Dry immediately using a soft cloth or paper towels. Cleaning Heat Distribution Plate: Heat distribution plates should be cleaned whenever food or grease drippings accumulate to reduce the chance of flare-ups. Wash heat distribution plates with a mild detergent and rinse with hot water. Use a degreaser and fiber or brass cleaning brush to remove stubborn food residue. Do not use a wire brush or metal scraper on porcelai

Propane gas is extremely flammable, follow these instructions: • Use only LP gas cylinders marked "Propane" which are U.S. Department of Transportation (DOT) certified. • Always use the gas pressure regulator supplied with this product which is regulated for an outlet pressure of 15 PSI; the use of other regulators or no regulator could result in dangerous gas leakage. • Check all gas connections by following directions in the "Gas Leak Testing" section of this manual. Never test for gas leaks w

Heat Grease Cup Shield Plate Step 12 Place grease cup in middle of hole in heat shield plate. 27 Note: When performing Step 13, Lift grill body from front and rear panels to avoid injury to hands and fingers. Be sure to pass hose/regulator assembly above cart frame crossbar. Step 13 With the help of a friend, place grill body assembly on assembled cart frame. Grill body will rest on angled top of vertical supports. Align bolt holes located on the outside of the grill body assembly. Secure using

SAVE THIS MANUAL FOR FUTURE REFERENCE. Step 1 Attach the ground stake to a pointed connector. Push approximately 3" of the ground stake into the ground. If the ground is too hard, soak area with water to soften. Step 2 Align the connector to the grooves on bottom of light head. Turn counter-clockwise to set in place. Step 3 Insert light head into ground stake. The photocell light sensor should point away from other nighttime light sources. Step 4 Charge in direct sunlight for 10-12 FULL, SUNNY D

These steps should be performed after the grill has been assembled and prior to each use. DO NOT operate this grill until you have read and understand ALL of the warnings and instructions in this manual. E • Ensure that the grill is properly assembled. • Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. If it is evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior the grill being used. • Leak check all gas connection

AVISO PARA EL INSTALADOR: ENTREGUE ESTAS INSTRUCCIONES AL PROPIETARIO DE LA PARRILLA PARA REFERENCIA FUTURA. AVISO PARA EL INSTALADOR: ENTREGUE ESTAS INSTRUCCIONES AL PROPIETARIO DE LA PARRILLA PARA REFERENCIA FUTURA. Universal Natural Gas Conversion Kit Equipo Universal de Conversion a Gas Natural PROFESSIONAL INSTALLATION MANUAL MANUAL DE INSTALACION PROFESIONAL CONVERTS THE FOLLOWING CHARMGLOW GRILLS FROM PROPANE TO NATURAL GAS: MODEL NUMBERS 810-7405-S, 810-8500-S, 810-8530-S, 810-8532-S, 81

ASSEMBLY INSTRUCTIONS Inspect contents of the Victorian Light Fixture 3-Piece Hanging Hook Ground Stake PARTS LIST: 1 2 3 1 2 3 Select a location with full, direct sunlight. Shady locations will not allow the battery to charge fully and will reduce the hours of nighttime light. NOTE: The rechargeable Ni-Cd battery must be allowed to fully charge to operate properly. Partially charging the battery on a consistent basis will drastically reduce the life of the battery. The selected location should

At night, the light turns on automatically using the electricity stored during that day. The number of hours the light will stay on is dependent on your geographical location, weather conditions and seasonal lighting availability. Solar lights do not receive as much direct sunlight in winter months. Therefore, the number of hours the light will stay on will be reduced during winter. BEFORE FIRST USE – Pull out to remove the clear plastic strip with orange sticker in the light fixture to charge b