|
Anleitung Zusammenfassung
SAVE THIS MANUAL FOR FUTURE REFERENCE. Step 1 Attach the ground stake to a pointed connector. Push approximately 3" of the ground stake into the ground. If the ground is too hard, soak area with water to soften. Step 2 Align the connector to the grooves on bottom of light head. Turn counter-clockwise to set in place. Step 3 Insert light head into ground stake. The photocell light sensor should point away from other nighttime light sources. Step 4 Charge in direct sunlight for 10-12 FULL, SUNNY DAYS. The light will turn on automatically at night. Allow at least 10-12 cycles (i.e., 10-12 days and nights of charging and discharging) for the battery to charge to its full capacity. Deck/Wall/FenceMounting: Select a location with full, direct sunlight. Shady locations will not allow the battery to charge fully and will reduce the hours of nighttime light. Step 1 Mount the bracket to a deck, wall or fence using the two screws provided. Step 2 Align the connector to the grooves on bottom of light head. Turn counter-clockwise to set in place. Step 3 Insert light head into bracket. The photocell light sensor should point away from other nighttime light sources. Step 4 Charge in direct sunlight for 10- 12 FULL, SUNNY DAYS. The light will turn on automatically at night. Allow at least 10-12 cycles (i.e., 10-12 days and nights of charging and discharging) for the battery to charge to its full capacity. Changing Battery Step 1 Remove lens from top housing by turning lens counter-clockwise. Step 2 With top housing upside down (solar panel facing down), unlock housing plate by turning counter-clockwise. Step 3 Remove battery. Replace with new Ni-Cd rechargeable battery. Step 4 Lock housing plate by turning clockwise. Step 5 Attach the lens by aligning the slots with the grooves in top housing. Turn clockwise to lock in place. NOTE: These lights utilize L.E.D. (Light Emitting Diode) technology. There are no bulbs to replace. Cleaning It is important that the solar panel is kept free of dirt and debris. A dirty solar panel will not allow the battery to fully charge. This will shorten the life of the battery and cause the light to malfunction. Clean regularly with a dampened cloth or paper towel. IMPORTANT: The EPA Certified RBRC® Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery contained in our product indicates The Brinkmann Corporation is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERY™ for information on Ni-Cd battery recycling and disposal bans/restrictions in your area. The Brinkmann Corporation’s involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. Lens Housing Plate Battery Top Housing Solar lights can be left outside year round, even in cold weather. However, if you wish to store your light indoors for more than two or three days, follow these steps to prevent damage to rechargeable batteries: • Store at room temperature in a dry location. • Store solar light where it can receive some sunlight or room light each day. The batteries needs light to maintain a charge during storage. • During prolonged storage, units must be fully discharged and charged once every month or remove batteries and replace with new Ni-Cd rechargeable battery when ready for use. Check and replace batteries periodically throughout the year. • Do not store solar lights in a box, or a dark room without a source of light on the solar panel. This will damage the batteries and prevent their ability to hold a charge. • For best performance, do not store for prolonged periods. If your solar light does not turn on at night, it may be caused by ...
Dieses Handbuch ist für folgende Modelle:Andere Home Zubehör - 822-0408-0 (189.32 kb)
Andere Home Zubehör - 822-0408-4 (189.32 kb)