The password will be what you configured. •Network Isolation Configuration: By default, all network services are enabled. However, for security, any or all listening services may be disabled. Unselect any services that you wish to disable. These changes will not take effect until the next reboot. Online Update You may configure your device server to make a connection to an update server and obtain updated software or configuration information from the server or send information to the server. FI
Management and Diagnostic Console Broadband Link - Configuration Page The Broadband Link – Configuration page allows you to modify specific broadband connection settings. Figure 28. MDC Broadband Link Configuration Page Note: Modifying the settings on this page can impact the ability of computers on the local network to access the broadband connection. You should modify these settings ONLY if you are thoroughly familiar with networking. Management and Diagnostic Console Modifying DSL and ATM Set
If you see a picture of the modem with a red X, it means Wireless ACE cannot communicate with the modem. Check that: • The modem is On. • The cable is properly installed. • The antenna is on securely. • Dial-Up Networking has established a connection to the modem. • If you are on a LAN, ensure your machine’s IP address is not in the 10.x.x.x network (e.g.: 10.0.0.1 or 10.1.23.5, etc.) • If you receive an Error 629 or Error 630 while connecting to the modem with DUN, ensure there is nothing else
The AP uses only the legal frequency channels allowed in that regulatory domain. Wireless Broadband Router User Manual • Wireless Bridge AP Mode: Select wireless operating mode of the Wireless Broadband Router. The Wireless Broadband Router can work as Access Point or Wireless Bridge. • Access Point. When operating as an access point, the router provides connection between the wired and the 802.11 b/g wireless devices. This is the default operating mode. Figure 4-12 Access Point Mode Wireless Br
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusions may not apply to you. 7. Miscellaneous. This Agreement and the licenses granted hereunder are assignable or transferable by Licensee only in conjunction with the sale and transfer of the 2Wire Product within which the software was first delivered. 2Wire may assign this Agreement in whole or in part. Any notice, report, approval or consent required or permitted hereu
14. Click OK. D-Link Air DWL-650 Consult the documentation provided with your wireless adapter to install the D-Link Air DWL-650, then follow these steps: 1. From the Start menu, select Programs > D-Link DWL-650 Control Utility > Configuration Utility. 42 2. The D-Link Air DWL-650 Configuration screen appears. 3. Select the Configuration tab. 4. In the Mode field, enter Infrastructure. 5. In the SSID field, enter the word “2WIRE” followed by the last three digits of your HomePortal serial number
See Fig. 4.16 Fig. 4.16 Step 23 Type in a name for your printer, select if you want to set it as the default printer, and click Finish. See Fig. 4.17 Fig. 4.17 Section 5 Section 5 Using the Web Configuration Utility You can use the Web Configuration Utility to configure the settings for your PrintServer. There are four sections to choose from: Management, Configuration, Tools, and Help. Note: As an option, you can also use the Print Server Admin utility (PS Admin) included in the provided CD to
The following messages contain information that can help you resolve some of the most common installation or network conflicts. Excessive Sessions Warning This error message typically occurs when your PC has been infected with the Blaster Virus or similar agent. The error message appears because too many simultaneous Internet sessions are opened, which impairs both network and PC performance. Check the PC with an anti-virus program using the latest virus updates to identify and remove the infect