. Contents The FCC Wants You to Know ................................................................................................ 3 FCC Declaration of Conformity ......................................................................................... 3 Features .................................................................................................................................. 3 Preparation ........................................................................................
• Slide cover back and insert two AA batteries. • Or, use an AC adapter (not included) for power. The Ambient Information Network signal strength indicator will verify your coverage. Within 30 minutes, you will see the five-day forecast for conditions and temperature ranges. The current temperature will flash. Note: Your product receives information wirelessly from the Ambient Information Network, so there is no need to install a remote thermometer, rain collector, or any outside instrumentation
3. Screw the cable’s F-connector onto the matching transformer. 4. Slip the weather boot over the connection. If you use a rebuilt cable without a weather boot, cover the connection with weather-resistant tape. Using Twin-Lead Cable Main Lead-In Terminal Twin-Lead CableStrain-Relief Tab Boom Flat Washers Large Wing Nuts To connect flat, twin-lead cable to your antenna: 1. Split one end of the twin-lead cable for a length of about 3 inches. Then strip about 1/2 inch of insulation from both leads.
Your RadioShack VHF/UHF/FM Antenna performs better than standard antennas because of its special design features. UHF Bowtie — delivers more of the UHF signal to your TV. Since UHF signals are more difficult to receive than VHF signals, this antenna gives UHF signals the extra boost they need. VHF/UHF Isolation Network — prevents the two types of TV signals from interfering with each other. This results in cleaner signals and a better picture on your TV. BEFORE YOU BEGIN Before you begin install
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. RadioShack Customer Relations 300 RadioShack Circle, Fort Worth, TX 76102 12/99 Before You Begin Before you begin installation, read this manual and the separate Consumer Product Safety Commission information sheet. For your safety and convenience, plan each step of the installation and purchase the necessary hardware in advance. The hardware required and the order in which you perfo
Main Boom Cradle Boom Mast Clamp Assemblies Metal Support Straps Metal Support Straps 4. Press the supplied large end plugs into the main boom and the cradle boom. 5. Pull the UHF bowtie’s two halves away from the main boom until they lock into place. Then slide each half’s unattached end over one of the antenna’s lead-in terminals (one for each half of the UHF bowtie on each side of the boom). Lead-In Terminal UHF/VHF Isolation Network UHF Bowtie Note: Both sections of the UHF/VHF isolation net