The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5 kPa). 6” (side) 12” GAS LINE INSTALLATION NOTE: This section is intended as a guide for qualified technicians installing gas to this Unvented Fireplace. GAS LINE HOOK-UP SHOULD BE DONE BY YOUR GAS SUPPLIER OR A QUALIFIED SERVICE PERSON. NOTE: BEFORE YOU PROCEED, BE SURE YO

Framing height is a minimum of 55”. Construct framing using dimensions shown depending on your particular installation. B A 36" long 1/2” NPT SCHD 40 flexible gas line complying with the National Fuel Gas Code ANSI Z223.1-1988/NFPA 54, may be run from the regulator to the exterior of the Unvented Fireplace for access to your incoming 1/2" NPT black iron gas line or you may route incoming gas line directly to the regulator. A FRAMING DIMENSIONS Widths A Height B Depth Sonoran 36 44” 39” 27” Sonor

In addition to instructions for installing and maintaining this fireplace, it contains information that will enable you to obtain replacement parts or optional accessory items when needed. Keep it with your other important papers. CHECK LOCAL CODES BEFORE INSTALLATION Carefully review the instructions supplied with the decorative type unvented room heater for the minimum fireplace size requirement . DO NOT INSTALL AN APPLIANCE IN THIS FIREBOX UNLESS THIS FIREBOX MEETS THE MINIMUM DIMENSIONS REQU