Install the backing plate as shown in the illustration below. Page 1 of 4 TRAVIS IN DUSTRI HOUSE OF FIRE Printed April 16, 2008 Avalon Hideaway Bungalow Face (95700121) 2 Hang the left and right doors on the backing plate. Attach the handles and verify magnet position (if applicable). Page 2 of 4 ^,u,,iMoDru?";i# Printed April 16, 2008 Avalon Hideaway Bungalow Face (95700121) PUSH-ON FACE BRACKETS NOTE: The push-on brackets are only compatible with the 21 TRV (2008 or later). Overview

Attach the mounting brackets included with this kit to the back of the glass frame, using the nuts removed earlier - make sure the brackets are installed with the notch on the lower side of the bracket (see Figure 1, item “b”). 2 Attach the glass frame to the fireplace by inserting the tabs on the mounting brackets into the slots on the fireplace (see Figure 2). Magnets hold the mounting brackets in place. Figure 2 Page 1 of 1 17601562 - 12/16/08 © Travis Industries, Inc.

Easy to start, easy to operate and easy to maintain. The Astoria Bay is designed to turn your inefficient open fireplace into a power house home heater (45,100 BTU/Hour). Adjust the feed rate to low and with the maximum fuel load (82 lbs.), you can expect up to 52 hours of continuous heating. Use the provided wall thermostat and stretch the burn time even longer. The computerized control panel allows you to operate the Astoria Bay manually or change to a fully automatic mode with the push of a b

4 Restore the fireplace to the correct configuration. AA AA AA Hold the side firebacks at a slight angle and place them into position (both sides). AA A AA AA A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAA

This allows the doors to be aligned left or right, top to bottom. NOTE: place a rag over the hinge posts before grasping the hinge posts with pliers to prevent scratching. Page 1 of 1 6/19/08 © Travis Industries, Inc.

This allows the doors to be aligned left or right, top to bottom. NOTE: place a rag over the hinge posts before grasping the hinge posts with pliers to prevent scratching. Page 1 of 1 6/19/08 © Travis Industries, Inc.

Please familiarize yourself with the Owner's Manual before operating your heater and save the manual for future reference. Included are helpful hints and suggestions that will make the operation and maintenance of your new heater an easier and more enjoyable experience. We offer our continual support and guidance to help you achieve the maximum benefit and enjoyment from your heater. Important Information No other DVS Insert has the same serial number as yours. The serial number is below and to

This allows the doors to be aligned left or right, top to bottom. NOTE: place a rag over the hinge posts before grasping the hinge posts with pliers to prevent scratching. Page 1 of 1 6/19/08 © Travis Industries, Inc.

This allows the doors to be aligned left or right, top to bottom. NOTE: place a rag over the hinge posts before grasping the hinge posts with pliers to prevent scratching. Page 1 of 1 6/19/08 © Travis Industries, Inc.

-Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. -Installation and service must be performed by a qualified installer, service