2 2. GENERAL DESCRIPTION ......................... 3 3. FEATURES ................................................. 3 4. HANDLING PRECAUTIONS ...................... 3 5. NOMENCLATURE AND FUNCTIONS Front ............................................................ 4 Rear ............................................................. 4 6. INSTALLING THE WTU-4800 TUNER MODULE ....................................... 5 7. PRECAUTIONS ON ANTENNA INSTALLATION .......................................... 5

300 So. San Francisco, CA 94080 1-650-588-2538 / 1-800-733-4750 V1, . All Rights Reserved, 2002 VS-900 Architects and Engineering Specifications v1.0 1 GENERAL ................................................................................................................................ 4 1.1 MANUFACTURER ............................................................................................................ 4 1.2 CONTRACTOR ..................................................................

CONSUMER: Retain this manual for future reference. US WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO- SION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. FOR YOUR SAFETY: What to do if you smell gas: • DO NOT light any appliance. • DO NOT touch any electrical switches. • DO NOT use any phone in your building.

TROUBLE SHOOTING GUIDE Repairing of the EXES-5000 system is basically done by replacing defective units with good ones. The system's faults in an installation can be divided into the fol lowing categories. 1. Faults in an exchange 2. Faults in a station 3. Cable faults To make system repairing easier, find which category is involved, then refer to the chart below for assistance in fault finding. All stations do not operate. Fault in specific station Same symptom in every station. only. Fault in

Numero de la piece 700,029CF. INSTALLATION INSTRUCTIONS DIRECT VENT SSDV-35/40 SERIES OTL Report No. 116-F-29-5 Millivolt Models Electronic Models MODELS P/N 700,029M REV. E 11/2006 DIRECT VENT GAS FIREPLACE HEATERS SSDVT-3530CNM SSDVR-3530CNM SSDVT-4035CNM SSDVR-4035CNM SSDVT-3530CNE SSDVR-3530CNE SSDVT-4035CNE SSDVR-4035CNE This appliance may be installed in an aftermarket permanently located, manufactured home (USA only) or mobile home, where not prohibited by local codes. This appliance is o

Table F H Maximum V Minimum feet (meter) feet (meter) 3 (0.914) Elbow Only Table G H Maximum V Minimum feet (meter) feet (meter) 5 (1.524) 1 (0.305) 10 (3.048) 2 (0.610) 15 (4.572) 3 (0.914) 20 (6.096) 4 (1.219) V + H = 40 feet (12.2 m) Max. H = 20 ft. (6.096 m) Max. Square termination (SV4.5HT-2) shown. Square termination (SV4.5HT-2) shown. See Table 12 as an aid in venting component selection for a particular range of exterior wall thicknesses. See Table 12 as an aid in venting component selec

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL THE LIGHTNING FLASH WITH ARROWHEAD WITHIN A TRIANGLE IS INTENDED TO TELL THE USER THAT PARTS INSIDE THE PRODUCT ARE A RISK OF ELECTRIC SHOCK TO PERSONS. THE EXCLAMATION POINT WITHIN A TRIANGLE IS INTENDED TO TELL THE USER THAT IMPORTANT OPERATING AND SERVICING INSTRUCTIONS ARE IN THE PAPERS WITH THE APPLIANCE. Please follow the instructions in this manual to obtain the optimum results from this unit. We also recommend you to keep this manual handy f

TABLE OF CONTENTS 1. SAFETY PRECAUTIONS 2 2. GENERAL DESCRIPTION 3 3. FEATURES 3 4. HANDLING PRECAUTIONS 3 5. NOMENCLATURE 4 6. INSTALLATION 6.1. Direct Wall/Ceiling Mounting Without Using an Electrical Box 5 6.2. Mounting the Speaker to an Electrical Box Using The Adapter Frame 8 6.3. Mounting the Speaker Directly to an Electrical Box 9 6.4. Removing the Trim Piece 9 7. REPAINTING THE GRILLE AND TRIM PIECE 10 8. PROTECTION CIRCUITRY INFORMATION 11 9. EQUALIZATION 12 10. SPECIFICATIONS 12 Access

OPERATING OF CP UNIT AND NO. 200 PROGRAMMING 1. Precautions for Installation of CP-63 11 2. Initial CP 63 set up 12 3. Trouble Shooting 13 4. CP-63 DIP Switches for Function Selection 16 5. Dip Switch Selection and Station No. 200 Programming for Each Function 17 6. Function Code Table for Station No. 200 Programming 18 7. Station No. 200 Programming for Each Function 21 [Function Group A] FUNCTION CODE 7-1 Executive Priority (Highest Priority) 50 21 7-2 Continuous Calling Tone 51 22 7-3 Station

KOBE, JAPAN 1.Introduction...................................................... 1 2. Introduction of the EX-16 System............................... 1 2.1 Exchange................................................ 1 2.1.1 Features 2.1.2 Specifications 2.1.3 Further Details 2.1.4 System Block Diagram 2.2 Stations................................................... 7 2.2.1 Features 2.2.2 Specifications 2.3 Accessories ............................................ 8 2.3.1 Wall Mounting Panel (YC-100)