1 THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Important Safety Advice: When using electrical appliances, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to persons, including the following : • If the appliance is damaged, check immediately with the supplier before installation and operation. • Do not use this heater in the immediate surroundings of a bath, shower or swimming pool. • Do not use outdoors. • This

Concept Remote Blower CONTENTS WARNING 3 CHARACTERISTICS 5 INSTALLATION 8 USE 13 MAINTENANCE 14 2 EN READ THESE INSTRUCTIONS BEFORE YOU START INSTALLING THIS RANGEHOOD READ AND SAVE THESE INSTRUCTIONS WARNING: - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium setting. Always turn hood ON when cooking at high heat or when flambeing food (i.e. Crepe

Dieses Modell ist zur permanenten Wandbefestigung in einer Mindesthohe von 300mm konzipiert. Die Wandhalterung ist in waagerechter Position zu befestigen und das Kabel muss – wie in Abb. 1 gezeigt – nach rechts unten am Heizgerat verlaufen. Um einen optimalen Blick auf das Brennstoffbett zu erhalten wird ein Abstand von 600mm zwischen unterer Abschlusskante des Heizgerats und dem Fu.boden empfohlen (siehe Abb. 2 zu empfohlenen Abmessungen zur Befestigung). Um optimale Sicht zu gewahrleisten – ma

You will need a 1” wide suction cup, available thru Faber or local hardware store. Step 1: Purchase a new MR-11 or MR-16 (Pellicano), 12 volt, 20 watt halogen bulb with a glass lens cover. Step 2: Using the suction cup gently push against the bulb in the hood making a seal around the bulb. Step 3: Pull down on the bulb with the suction cup, to remove the bulb from the hood Step 4: Place the new bulb into the hood, lining up the bulb prongs with the holes inside the hood. For more informatio

gainst the bulb in the hood making a seal around the bulb. Step 3: Pull down on the bulb with the suction cup, to remove the bulb from the hood Step 4: Place the new bulb into the hood, lining up the bulb prongs with the holes inside the hood. For more information please call Faber at 508-358-5353 or email info@faberonline.com Step 1 Step 2 Step 3 Step 4