All rights reserved. FLUKE 1652C/1653B/1654B Users Manual Supplement Change #1, 56800 On page 3, add the following bullet: • Do not use in CAT III or CAT IV environments without the protective cap installed. The protective cap decreases the possibility of arc flash caused by short circuits. On page 6, under Operating the Tester Using the Rotary Switch, add the following: WWarning Do not use in CAT III or CAT IV environments without the protective cap installed. The protective cap decrea

This manual is distributed as an electronic manual on the following CD-ROM: CD Title: 1652C/1653B/1654B CD Rev. & Date: 9/2010 CD PN: 3798444 © 2010 Fluke Corporation. All rights reserved. FLUKE 1652C/1653B/1654B Users Manual Supplement Change #1, 56800 On page 3, add the following bullet: • Do not use in CAT III or CAT IV environments without the protective cap installed. The protective cap decreases the possibility of arc flash caused by short circuits. On page 6, under Operating th

The protective cap decreases the exposed probe metal to <4mm. This decreases the possibility of arc flash from short circuits. On page 45, under General Specifications, add the following to the Safety section: Complies with EN/IEC 61010-031:2002+A1:2008. 12/10 1

Properly connected, the probe is rated to 15 kV Overvoltage Category I. The use of the probe is restricted to low energy applications, which are energy limited circuits like electrostatic air cleaners. Do not use this probe to measure high voltages on power distribution systems. The probe is a precision 1000 : 1 voltage divider formed by two matched resistors. The unusually high input impedance offered by these resistors minimizes circuit loading and thereby optimizes measurement accuracy. WRead

2 ©2004, 2005 Fluke Corporation, All rights reserved. Printed in U.S.A. All product names are trademarks of their respective companies Fluke Biomedical Radiation Management Services 6045 Cochran Road Cleveland, Ohio 44139 440.498.2564 Table of Contents Section 1: General Information................................................................................... 1-1 1.1 Introduction .................................................................................................. 1-1 1.2 Descr

Chapter 2 of the Users Manual of the ScopeMeter explains how to display the software version. This Chapter also explains how to exchange the Battery Pack. After installation, charge the Battery Pack for at least 7 Hrs. with the ScopeMeter switched off. • Nominal Voltage: 4.8 V • Capacity: 3.0 Ah • Lifetime: minimum 500 cycles at nominal charge of 500 mA • Temperature Ranges: Operating: 0 ° C to 50° C Quick Charging: 10° C to 40° C Trickle Charging: 10° C to 45° C Storage: -40° C to 60° C Perform

After installation, charge the Battery Pack for at least 5 Hrs. with the ScopeMeter or Power Quality Analyzer switched off. • Nominal Voltage: 4.8 V • Capacity: 2.0 Ah • Lifetime: minimum 500 cycles at nominal charge of 500 mA • Temperature Ranges: Operating: 0 ° C to 50° C Quick Charging: 10° C to 40° C Trickle Charging: 10° C to 45° C Storage: -40° C to 60° C Performing a Refresh Cycle every 3 months, will contribute to the lifetime of the Battery Pack. To prevent damage to Equipment or Batter

Amp. 70 % 100 % 30 % 24 % 48 % 100 % 120 % 112 % 80 % Lead I reference Performance waves and R wave detection Lead # I II III V1 V2 V3 V4 V5 V6 Ref. Amp. 100 % 150 % 50 % 100 % 100 % 100 % 100 % 100 % 100 % Normal Sinus waves Lead # I II III V1 V2 V3 V4 V5 V6 Ref. Amp. 100 % 150 % 50 % 24 % 48 % 100 % 120 % 112 % 80 % ECG Normal Sinus Rates................................................................... 10 to 360 (by 1) BPM ECG High Level Output (BNC Jack) Amplitude Range ....................

& Date: 1, 2/2008 CD PN: 3028681 © 2008-2009 Fluke Corporation. All rights reserved. Printed in the U.S.A. Impulse 6000D/7000DP Users Manual Supplement Change #1, 46470, 46697, 47714, 48007, 49680 Replace pages 31 through 35, with the following: Defibrillator Analyzer Specifications Energy Output Measurement Compatible Defibrillator Waveshapes ................ Lown, Edmark, Trapezoidal, DC Bi-phasic, and AC Pulsed Bi-phasic Note AC Pulsed Biphasic waveform has not been approved in the United Sta