State if you are using a Standard or Special Bill of Materials. Give as much of the above required information as possible. ON WARRANTY: CAMCO will send replacement parts freight prepaid via the most practical means. CAMCO will issue a "Returned Material Authorization Number" (RMA#) for the return of defective parts for inspection. CAMCO will invoice customer for repair parts. When inspection of returned parts has been completed and determined to be a warranty problem, CAMCO will then issue a cr

This also positions the seal correctly on the shaft. 9. When an installation tool cannot be manufactured, install the seal by tapping uniformly around the seal with a soft hammer. Avoid cocking the seal and make sure the face of the seal is square to the bore. CAM FOLLOWER REPLACEMENT: CAM FOLLOWER REMOVAL: Instructions for replacing cam followers assume the cam and follower wheel will not be removed. If the follower wheel will be removed, proceed to the section titled "Follower Wheel and/or Out

Failure to deliver this, could result in your liability for injury to the user or damage to the machine. For copies of this manual call your Customer Service Representative 800/645-5207. WARNING TABLE OF CONTENTS INTRODUCTION: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 WARNINGS AND CAUTIONS: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 SPARE PARTS KIT: . . . . . . . . . . . . . . . . . . .

CAUTION Make sure the cam is not damaged during this process. 4. Install threaded rod and lift ring into the lifting hole in the cam. Then lift the cam so the input shaft can be pushed through the cam. 13 4.1. Reverse one of the methods described for lowering the cam into the housing when lifting the cam. See section titled "Cam and/or Input Shaft Replacement" in this Service Manual. INPUT SHAFT INSTALLATION: 1. Prepare the input shaft for installation by installing the locknuts and lockwasher o