2. The OFFSET MODE can be used to offset the set / displayed temperature from the sensed temperature by as much as ± 35.F, in 5.F increments: a. Rotate the TIME controller until the time digits on the display read "00:00". b. Rotate the TEMP control until the temp digits display between 400. and 500.. c. Press and hold the START TIMER key for five seconds. d. Turn either the TIME or TEMP control until the desired offset is displayed. e. Press the ACTUAL TEMP key to exit. CAUTION ELECTRIC SHOCK H
Allow broiler to cool completely. Disconnect broiler from electric power. FREQUENCY Daily. TOOLS Steel Brush with scraper Plastic Scouring Pad, Soft-Bristled Fiber Brush Mild Detergent, Non-Abrasive Cleanser Clean Soft Cloth / Sponge CLEANING 1. Remove the grates from the charbroiler. Clean grates: a. Use the supplied steel brush with scraper to remove food particles and residue from grate surfaces. b. Grate may be washed in sink or dishwasher. c. Dry the grate and apply a light coating of cooki
This appliance is intended to prepare food for human consumption. No other use is recommended or authorized by the manufacturer or its agents. This appliance must be installed by a technician qualified and certified or licensed to install gas-fired equipment. A licensed technician must perform the initial start-up and adjustment of the appliance. Operators of this appliance must be familiar with the appliance use, limitations and associated restrictions. Operating instructions must be read and u
When used with an exhaust fan, special precautions must be observed to avoid interference with the operation of the charbroiler, such as drafts and air starvation. NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation. Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual. DANGER: Health Hazard This appliance must be properly ventilated. Failure to provide and maintain pro
Leak checks should be performed with a soap and water solution. IMPORTANT: Information on the construction and installation of ventilating hoods may be obtained from the current edition of NFPA 96 Standard for the Installation of Equipment for the Removal of Smoke and Grease Laden Vapors from Commercial Cooking Equipment. Copies of this standard are available from the Nation Fire Protection Assn.: NFPA 1 Batterymarch Park P.O. Box 9101 Quincy, MA 02269-9101 5 INSTALLATION (continued) DANGER: Fir
THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment. 503 p/n 304989 Rev. B ECN-12660 M503 040318 cps OPERATION MANUAL WVF-886 SERIES DUAL AUTO-LIFT STS™ FRYER with UNIVERSAL HOOD Includes INSTALLATION USE & CARE Model WVF-886 PRINTED IN UNITED STATES OF AMERICA LIMITED WARRANTY STATEMENT LIMITED WARRANTY STATEMENT Unless otherwise specifie
A S211 111000 cps IMPORTANT: WELLS MFG. PROPRIETARY INFORMATION TECHNICAL CONTENT OF THIS MANUAL IS DESIGNED FOR USE BY QUALIFIED PROFESSIONAL TECHNICIANS ONLY WELLS MANUFACTURING COMPANY 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 Customer Service (775) 345-0444 Ext.502 fax: (775) 345-0569 211 GENERAL SAFETY PROCEDURES Knowledge of proper procedures is essential to the safe operation of electrically energized equipment. In accordance with generally accepted product safety labeling guidelines f
VENTILATOR OPERATION 1. Press the VENTILATOR POWER switch to ON. The green VENTILATOR POWER light will glow and the blower fan will start. After a short time, if all filters are sensed as being in position and not clogged, the cooking appliance will be energized. The roll warmer is energized at all times. During normal operation, the VENTILATOR POWER light will be the only light glowing on the upper control panel. 2. If the amber CHECK FILTER light glows, one or more filter elements is out of po
Replacing both the pre-filter and the filter pack will remedy the situation. Note: replacing the pre-filter, even though not very dirty, will often extend the service life of the more expensive filter pack. Reset the unit by turning the VENTILATOR POWER switch to OFF, then back ON. 6. A failure of incoming electrical power will cause a shut down of the unit. After power is restored, reset the unit by turning the VENTILATOR POWER switch to OFF, then back ON. Fig. 8 Ventilator Indicator and Warnin
appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life. This manual contains the information needed to properly install this appliance, and to use and care for the appliance in a manner which will ensure its optimum performance. SPECIFICATIONS MODEL VOLTS 1o WATTS AMPS POWER SUPPLY CORD WPP-6 120 VAC 1200 W 10 A NEMA 5-15P WPP-10 120 VAC 1500 W 12.5 A NEMA 5-15