LP-ET30L Throw Distance(Aspect ratio horizontal:vertical ^4:3) Throw Distance:unit(m) Type On-Axis Short Fixed Lens Short Zoom Lens Standerd Zoom Lens Long Zoom Lens Ultra Long Zoom Lens Part Number LNS-W11 LNS-W10 LNS-S11 LNS-T10 LNS-T11 Zoom/Focus Fixed/Manual x1.3/Power x1.3/Power x1.6/Power x1.6/Power Twin stack support X X X X X Focal length(mm) 16.51 25~33 33~43 43~69 69.1 — 109.2 F value 2.3 2.3~2.6 1.7 — 2.1 2.0~2.6 2.1—2.52 lens aperture (mm) 97 9

LNS-M01 LNS-S01 LENS REPLACEMENT AND INSTALLATION PROCEDURE NOTES ON LENS INSTALLATION Lens installation should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to install the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens. If you have any questions, contact to the dealers. PARTS LIST Following parts are contained in the packing. • LENS 1 piece • LENS MOUNTING SCREWS 6 screw

(Refer to Figure 1) 2. Pull out the terminal by holding the handle. 3. Replace the terminal. Insert the terminal along Guide to fit Plug into Socket. (Refer to Figure 2) 4. Tighten the screws to secure the terminal. ♦ These figures show the case of replacing with HDB 15-PIN terminal. Figure 1 Screws Figure 2

(Refer to Figure 1) 2. Pull out the terminal by holding the handle. 3. Replace the terminal. Insert the terminal along Guide to fit Plug into Socket. (Refer to Figure 2) 4. Tighten the screws to secure the terminal. ♦ These figures show the case of replacing with HDB 15-PIN terminal. Figure 1 Screws Figure 2

(Refer to Figure 1) 2. Pull out the terminal by holding the handle. 3. Replace the terminal. Insert the terminal along Guide to fit Plug into Socket. (Refer to Figure 2) 4. Tighten the screws to secure the terminal. ♦ These figures show the case of replacing with HDB 15-PIN terminal. Figure 1 Screws Figure 2