Nos. 1692210, 1692231, 1692353, 9000100 A WARNING Turn off the engine, let the rotor come to a complete stop and disconnect the spark plug wire before assembling the vacuum kit or changing attachments. A WARNING Never remove% adapter from the back of the machine while the machine is running or the rotor is turning. The rotor is pinning just inches away from the adapter iniet. Serious injury will result if you put your fingers or foot in the adapter inlet while the rotor is turning! INSTALL

10/5/06 9:35 AM Page 1 Maintenance Before performing any maintenance, ALWAYS unplug worklight. Remove dirt and grime as soon as it accumulates. Use a soft, damp cloth and a mild soap, if needed. Be sure not to get the electrical plug wet. NEVER submerge any part of the worklight in any solution to clean it. DO NOT USE solvents such as gasoline, turpentine, etc. to clean unit. Aerosols and other chemicals may fog the clear polycarbonate lens. One Year Full Warranty on Worklight If this produc

Password can be easily changed if desired. Temporary password: Can be added for visitors or service persons. This temporary password can be limited to a programmable number of hours or a programmable number of entries. Rolling Code: While your password remains constant until you change it, the code between the Keyless Entry and the receiver changes with each use, randomly accessing over 100 billion new codes. Operation: Opener activates when 4-digit password and Enter button is pressed. If wrong

Service will be scheduled according to the normal work flow and business hours at the service center location, and the availability of replacement parts. All decisions of Porter- Cable Corporation with regard to this limited warranty shall be final. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. RESPONSIBILITY OF ORIGINAL PURCHASER (initial User): • To process a warranty claim on this product, DO NOT return it to the retailer. Th

plate is located on the frame. Record these numbers in the spaces below and retain for future reference. Model No. Type Serial No. Part No. D26052-023-0 BEFORE ASSEMBLY 1. Shut off the pressure washer and turn off the water supply. 2. Pull trigger on gun handle to relieve any water pressure. 3. Disconnect the high pressure hose from the gun. TO ASSEMBLE HOSE REEL 1. Attach handle to flange assembly. NOTE: Screws must be inserted from the inside of hose reel and secured with nuts on the outside a

CONNECT RECEIVER AND OPENER: Remove about 1/4" of insulation from each end of the 2-strand bell wire. Connect one end to the receiver screw terminals (polarity is NOT required). Route wire along the channels and out the bottom as shown. Connect the other end of the bell wire to the two opener terminal screws labeled "2" (white) and "1" (red), "common" and "command" or the terminals used for the push button control. Use insulated staples (not supplied) to secure bell wire between receiver and ope

Install the receiver (or any additional push buttons) out of the reach of children and away from all moving parts of the door and door hardware, but where the garage door is visible. Do not allow children to operate the push button(s) or the remote control(s). A moving garage door could injure someone under it. Activate the opener only when the door is properly adjusted, you can see it clearly, and there are no obstructions to door travel• DISCONNECT POWER TO THE GARAGE DOOR OPENER REFOREPROCEED

4023 GB Operating Instructions Cylinder Lawnmower F Mode d’emploi Tondeuse helicoidale NL Gebruiksaanwijzing Kooimesmaaier S Bruksanvisning Handgrasklippare I Istruzioni per l’uso Rasaprato a mano E Manual de instrucciones Cortacesped helicoidal P Instrucoes de utilizacao Cortador de relva cilindrico DK Brugsanvisning Handpl.neklipper DGBFNLSIEPDK GARDENA Cylinder Lawnmower 300 / 380 Welcome to the Garden of GARDENA... GB Please read these operating instructions carefully and observe the notes g

Det samme g.lder for ekstra udstyr og tilbehor. Deutschland / Germany GARDENA Manufacturing GmbH Service Center Hans-Lorenser-Stra.e 40 D-89079 Ulm Produktfragen: (+49) 731 490-123 Reparaturen: (+49) 731 490-290 service@gardena.com Argentina Argensem® S.A. Calle Colonia Japonesa s/n (1625) Loma Verde Escobar, Buenos Aires Phone: (+54) 3488494040 info@argensem.com.ar Australia Nylex Consumer Products 50-70 Stanley Drive Somerton, Victoria, 3062 Phone: (+61) 1800 658 276 spare.parts@nylex.com.au A

(254 mm) COMPOUND MITER SAW Item No. _924310 _924350 Save this manual for future reference. • SAFETY _, CAUTION: Read and follow • LOOSE PARTS all Safety Rules and Operating Instructions before first use of • INSTALLATION this product. • SERVICES Customer Help Line: t-800-932-3188 Sears, Roebuck and Co., Hoffman Estates, IL 60179 USA Visit the Craftsman web page: 972000-603 2-00 READ ALL INSTRUCTIONS • READ THESE INSTRUCTIONS AND THE INSTRUCTIONS FOR THE 315.212100 COMPOUND MITER SAW THOROUGHLY