(See Figure C.) 5. If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size. (See Figure C.) 6. If you are using an extension cord outdoors, make sure it is marked with the suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use. 7. Make sure your extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified ele

The third prong (round) is the ground. Plug the product’s cord only into three-prong receptacles. Never cut off the round prong. Cutting off the ground will result in a safety hazard and void the warranty. #38347 Page 4 Assembly 1. The Handle for the Lid (#4) needs to be assembled. Remove nuts and washers from Handle. Place Handle in place on front portion of Lid and tighten screws with washers and nuts. 2. Attach the black plastic Filter to the Pump (#28). It fits over the wide opening on the s

All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions and replacement parts, please call 1-800-444-3353. SPECIFICATIONS Item Description Capability 6 and 12 VDC battery tester with charging system output Load Test Capacity 100 amps; 50~1000 cold cranking amps Display Meter Analog, 0~16 VDC (maximum) Test Cycle 10 seconds per test with 1 minute cool

11. Never look directly into the Spotlight. 12. Avoid touching the Lens as it may become hot during operation. 13. Do not dissassemble the Battery or remove any parts from the Battery and surrounding connections. 14. Do not allow the Spotlight to be exposed to fire or high heat as this may result in an explosion. 15. Disconnect power. Unplug charger when not in use. 16. Maintenance. For your safety, maintenance should be performed regularly by a qualified technician. Warning: The warnings, cauti

All rights reserved. No portion of this instruction sheet or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions, please call 1-800-444-3353. SAVE THESE INSTRUCTIONS SAFETY WARNINGS AND PRECAUTIONS Always wear ANSI-approved safety impact eye goggles during setup or use. Maintain a safe working environment. Always keep the work area free of obstructions, grease, oil, trash, and other debris. Do n

No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions and replacement parts, please call 1-800-444-3353 Specifications Specifications 58-5/8” Wide X 27-1/4” Deep X 97” High Bench Max. Weight Capacity 200 Lbs. Materials White PVC-U.V. treated for Weather Protection Weight 89 Lbs. Save This Manual You will need the manual for the safety warnings and precautions, assembly

Warning! Always unplug the unit when changing bits. Warning! After drilling or driving screws, the bit will be extremely hot. Do not touch it until it has had ample time to cool down. 1. Insert the Chuck Key (41) into one of the holes in the Chuck (3) and turn it counterclockwise to open the jaws. 2. Insert the bit and hand tighten it, then tighten it with the Chuck Key (41) by turning it clockwise. Carbon Brush (also found on bottom of tool) Torque Switch Figure 1 Trigger Chuck Lock Button Side

If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. Operating Instructions Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product. To prevent serious injury from accidental operation: Turn the Power Switch to its off position and disconnect the Adapter Cord from its electrical supply source before per