Serrures a inversion de polarite a 4 ou 5 fils: l'un des fils est sous tension positive de 12V en permanence, un ou deux autres fils sont mis a la masse en permanence. Tous les autres fils sont sous tension positive de 12V lorsque la commande est dans l'une des deux positions (blocage ou deblocage) et la polarite s'inverse avec mise a la masse lorsque la commande change de position. (Dans certaines voitures, la tension positive de 12V accompagne la position "blocage" et la mise a la masse la pos

Confirm by pressing the O.K. button. If you use the built-in monitor loudspeaker, set the volume level in the OSD menu to the middle setting. Use the + and - buttons on the remote control to adjust the navigation audible messages. -3- MONITOR SPECIFICATIONS 1. Type: 2. Display Screen Size: 3. Resolution: 4. Monitor Characteristics: 5. Remote Operation: 6. Power Source: 7. Power Consumption: 8. Maximum Brightness: 9. Operating Temperature: 10. Monitor Cabinet Dimensions: 11. Weight

Although this transmitter can be programmed into any of the Audiovox remote start and or alarm, remote start systems, it will offer limited use and should be used for the remote start upgrade only. To program this transmitter into your remote start upgrade unit: 1) Turn the ignition to the on position 2) Press and release the programming switch 3 times 3) Press and hold, for 3 seconds, the button of the transmitter you wish to add until the parking light flashes indicating the transmitter ha

It is possible that you will need to manually override your security system if the transmitter becomes lost, or inoperative due to battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is necessary to fully understand the procedure required to enable your vehicle in such situations. In addition, the chart on the last page of this manual has a section for the particular features and options installed in your vehicle as well as the override method selected. Valet Switch manual

This allows you to program eachtransmitter to more than one vehicle in two car families and also allows youto change which button or buttons control certain functions of the system. (Example: Transmitter channel 5, shown below, can be programmed toactivate Receiver channel 2.) Refer to the chart below for access to each ofthe transmitter channels, and for the standard factory button assignments. TRANSMITTER SYSTEM RECEIVER CHANNEL BUTTONS CHANNEL FUNCTION 1 1 Remote Arm * Remote Emergency Panic*

*Depending on vehicle this can be under a seat, rear cargo area if S.U.V. or trunk of passenger car. 2. Take notice of any obstacles under mounting surface, such as harness under rug, fuel lines or fuel tank under vehicle that might be damaged by mounting of VPMP1. 3. After locating an area to mount plate, place VPMP1 down on location and align the plate so there is one mounting hole located in the front and 2 mounting holes in the rear. 4. Using Screw Gun and Nut Driver Attachment, secure VP

5. While in the video adjustment mode, press the up button (5) to increase the selected adjustment level or press the down button (6) to decrease the level. GENERAL INSTALLATION INFORMATION 1. Installation will vary from vehicle to vehicle, as headrests in vehicles are not standard. 2. This unit is intended for installation by professional installers. 3. The kit consists of the screen assembly, a mounting housing, key to remove screen from housing, wiring harness and remote control unit. 4. To r

5.6" Active Matrix LCD Monitor Owner.s Manua. EXPLANATION OF GRAPHIC SYMBOLS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with the arrowhead within a triangle is intended to alert tell the user that parts inside the product are capable of producing an electric shock . The exclamation point within a triangle is intended to a