UNIT WILL NOT PARK 1. Check unit on roof. Be sure there are no obstacles on the roof that prevent parking. 2. Was the PARK button on the wall plate controller pressed the correct number of times? See Control Panel Operation. 3. For the unit to park, the satellite receiver must be plugged into an active 120 VAC outlet, and the LNBF power from the receiver must be connected to the AS-2003. If this is not done, the unit will go to a “No LNBF Power” error (ON, PARK, SEARCH, OFF lighted) and will not

46 cm (18") Antenna height..................................... 53 cm Antenna width ...................................... 49 cm Gain at mid-range 11.2 GHz..............................33.22 dBi 12.1 GHz..............................33.89 dBi 12.6 GHz..............................34.23 dBi Effective aperture................................. 46 cm Aperture efficiency .................................. 73% Cross polarization (on axis)... ..............-21 dB Beamwidth at -3 dB ....................

5,532,710 WARNING! BEFORE ATTACHING OR REMOVING ANY CABLE/WIRES ON BACK OF POSITIONER, UNPLUG UNIT FROM 117 VAC SOURCE. Printed in U.S.A. Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 • 319/754-0600 © 1999 Winegard Company 2451172 Rev. 5/99 IMPORTANT SAFEGUARDS IMPORTANT SAFEGUARDS THIS SYSTEM HAS BEEN ADJUSTED AT THE FACTORY FOR OPTIMUM PERFORMANCE. BEFORE MAKING ANY ADJUSTMENTS, CONTACT WINEGARD CUSTOMER SERVICE. WARNING: TO REDUCE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EX

Patent Pending Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 • 319/754-0600 • FAX 319/754-0787 • Printed in U.S.A. © Winegard Company 2004, 2005 2452040 Rev. 12/19/05 Congratulations! Congratulations! ® and DISH Network® satellite television providers. This manual provides important information on the installation and operation of your RoadTrip LP antenna. Please take time to read the manual before installing or operating your antenna. Icons appearing in the manual are used fo

Be sure the mount has not been damaged. 2. Check for caulking on elevating shaft. 3. Contact your dealer or Winegard Technical Services. LCD DISPLAY CODES HL................High Limit LL..................Low Limit Lo................Batter Low Er.........................Error --..................Initializing NOTE: Initialization may take up to 5 seconds. 3. 4. 5. 6. 7. 8. 9. 1 2 4 7/09/04 Assembly & Installation Things you need — Screwdrivers (Phillips and slot) 1-3/4” hole

The directional handle and threaded rod will fit roofs up to 5-1/4” thick. If you are using wedges to compensate for roof/cceiling slope, be sure to allow for this extra thickness. You may add an extension to the directional handle for thicker roofs. Each extension will increase the length of the directional handle by 2-1/4”. Figure 11 FIGURE 11 STEP 16. Press the directional handle onto the hub. Point arrow on the directional handle towards the rotate/lock lever to orient to the splines. STE

If this is the reason, after you have rotated the antenna to the approximately correct compass direction, adjust to correct elevation and continue research. Special Note: When you have found the satellite signal, adjust the antenna u/down and right/left for the strongest signat your receiver displays. due to variation in receivers and installation methods, you may find the elevation numbers after peaking on strongest signal no long match what the receiver display recommended. This is normal. Th

Patent Number 5,532,710 Made in U.S.A. Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • Printed in U.S.A. © Winegard Company 2002, 2005 2451069 Rev. 12/05 Operation STEP 1. The more accurately you determine North, the easier it is to locate the satellite. Step outside and away from your vehicle. (Standing to near your vehicle can give incorrect compass readings.) It is helpful if there is a landmark on the horizon to represent North. Return to

Press and hold the [ENTER] button for 2 seconds. Press [SELECT] to choose Yes. Satellite Interface Enter User Menu? Yes No POWER ENTER SELECT * Press [ENTER] to confirm selection. You are now in the Main Menu. Press [ENTER] to confirm Satellite Setup. Satellite Interface Satellite Setup* Enter Sleep POWER ENTER SELECT Press [ENTER] to confirm Sat Provider. From Service Provider menu press [SELECT] to select Dish. Press [ENTER] to confirm. Satellite Interface Service Provider *DTV DISH BELL POWER

Patent Pending Converter required for DIRECTV HDprogramming only. Sold separately. Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 800/288-8094 • FAX 319/754-0787 • Printed in U.S.A. © Winegard Company 2007 2452114 Congratulations! You have selected the Winegard Satellite Interface, your source for High Definition Satellite Programming. The Satellite Interface Box enhances your RoadTrip™ or Movin’ View® Satellite Systems, allowing access to more satellites and more HD programmin