CONSULT LOCAL AUTHORITIES IF IN DOUBT ABOUT YOUR LOCAL FIRE SAFETY REGULATIONS. ALL INSTALLATIONS MUST BE MADE IN ACCORDANCE WITH LOCAL AND STATE OR PROVINCIAL CODES WHICH MAY DIFFER FROM THIS MANUAL. IMPROPER INSTALLATION WILL RESULT IN VOIDING OF WARRANTY. TW2000 WOOD-FIRED BOILER – INSTRUCTION MANUAL CONTENTS SECTION 1 – OPERATING INSTRUCTIONS Pg. Specifications 2 1.1 Introduction 3 1.2 Wood-Burning 3 1.3 Storage of Wood 4 1.4 Maximum Solid-Fuel Charge 5 1.5 Maintenance 5 1.5.1 Cleaning 5 1.6

installing, operating or performing maintenance on the unit.installing, operating or performing maintenance on the unit.installing, operating or performing maintenance on the unit.installing, operating or performing maintenance on the unit.installing, operating or performing maintenance on the unit. White-Rodgers is a division PART NO. 37-6359A PART NO. 37-6359APART NO. 37-6359APART NO. 37-6359APART NO. 37-6359APART NO. 37-6359A of Emerson Electric Co. Replaces 846-0291C Please read instructions

The control confirms these contacts are open at the beginning of each heat cycle. This would indicate a faulty pressure switch or miswiring. 3 RED FLASHES: This indicates the normally open pressure switch contact did not close after the inducer was energized. This could be caused by a number of problems: faulty inducer, blocked vent pipe, broken pressure switch hose or faulty pressure switch. 4 RED FLASHES: This indicates that a primary or auxiliary limit switch has opened its normally closed co

a. If the return air filter is on the left or right side of the furnace it is a side return b. If the air filter is on the bottom of the furnace then you have a bottom return. c. If the air filters are on the bottom and the side of the furnace then you have a bottom and side return. You must replace both air filters. Table 1 will indicate 2 filters by using brackets with the number two (2). d. If the air filters are on both sides of the furnace then you have a two sided return. You must replace

req’d) 46 TUBING, SILICONE (Preformed) 47 TUBING, SILICONE (Gray, .188 ID, 1.25 ft. req’d) 48 GASKET, COMBUSTION BLOWER 49 GASKET, CONDENSATE PAN 50 GASKET, UPPER CONDENSATE PAN (2 Req’d) 51 GASKET, GAS CONTROLS 52 GASKET, CONDENSING COIL 53 GASKET, COMBUSTION AIR TRANSITION 54 55 VENT PIPE 2” X 15.25” LG. 56 GROMMET, MOTOR (3 Req’d) 57 FERRULE (3 Req’d) 58 COMBUSTION BLWR RESTRICTOR 59 60 RETAINER, SQUARE 61 RESTRICTOR, TUBE 62 WASHER, FLAT FIBERGLASS (2 Req’d) 63 64 HARNESS, MAIN WIRING 65 MOU

With Media Filter ACM1000 ACM1200TM ACM1400 ACM1600 ACM2000 ACM2000U ACM2000X No Media Filter ACB1000 ACB1400 ACB1600 ACB2000 OWNER’S MANUAL • Installation • Operation • Technical Repair Guide • Repair and Upgrade Parts Please read and familiarize yourself with the contents of this manual before installing, operating or performing maintenance on the unit. White-Rodgers is a division PART NO. 37-6383C of Emerson Electric Co. Replaces 37-6383B INTRODUCTION The White-Rodgers Air Cleaner Compartment

With the 120 VAC power turned on at the circuit breaker for the furnace, push the air cleaner ON-OFF switch to the “ON” position (Figure 20). 2. With the furnace blower running, the air cleaner will be operating. An arcing or “snapping” sound may be heard. This will occur occasionally, however the unit is operating properly. 3. With the furnace blower running, the Operating Light should be ON. If the Operating Light is not ON this signifies that the cells need washing, or that trouble exists in

Blow on thermistor at air flow monitor. 120 VAC should appear at multimeter. Stop blowing and voltage should disappear in 10 - 15 seconds. 4. If voltage did not appear (Step 3), disconnect power to power pack. Locate air flow switch and remove power pack cover. Disconnect the three-pin plastic connector. Jumper the two female pins (white wire to white-brown wire) as shown in Fig. 23. Reconnect power to power pack. Turn power switch “ON.” A. If 120 VAC appears at multimeter, replace air flow moni

See Figure 7. The heating cycle is complete, and ready for the start of the next heating cycle. RED-LOW SPEED BLU-MEDIUM SPEED MOTOR LEADS BLK-HIGH SPEED BLK BLU RED 60 180 COOL HEAT PARK PARK LINE XM 120 FAN OFF ADJUSTMENT SWITCHES FIGURE 7: Typical Heat/Cool Speed Tap Connections Unitary Products Group 035-19592-001 Rev. C (0204) If the flame is not detected within 2 seconds of the gas valve opening, the gas valve is shut off and a retry operation begins. If the flame is lost for 2 seconds dur

TABLE OF CONTENTS CONTACT INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 USER’S INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 INSTRUCTIONS FOR EXAMINING THE FURNACE INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 HOW YOUR GAS FURNACE WORKS . . . . . . . . . . . . . . . . . . . . . .3 ST