2788. SEARS Captive Air* Tanks are pre-charged at the factory. Check the tank Owners Manual to find if air charge needs adjustment. Model FIGURE 7 390.251483 and Model 390.251883 require 40 pounds for proper operation. OPERATION The jet pump can also be mounted on standard horizontal tanks. A mounting kit with an AVC is furnished with tank. (Figure 6). Priming the Pump Instructions are also included. CAUTION IA j NEVER run pump dry. Running pump without TO SERVICE _ water may overheat unit, dama

SaveThisManual For FutureReference. CRRFTSMRN° PROFESSIONAL "HYDROGLASS ''® SHALLOW WELL JET PUMP • Safety Instructions • Installation • Operation • Troubleshooting • Repair Parts Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. PRINTED IN U.S.A. Form No F642-9906 (Rev, 4/18/01) READ AND FOLLOW SAFETY INSTRUCTIONS! Electrical Safety Wire motor for correct WARNING voltage. See "Electrical" section of this manual and motor nameplate. Ground motor before connecting to power supply. Meet Nat

operations • 8.5 cfm @ 40 psi 7.2 cfm @ 100 psi Applications Framing and Sheathing, Roofing and Decking Contractor Series Compressors PC2G14 B.5 hp Honda® Engine Wheelbarrow Oil-Splash Compressor Powerful wheelbarrow oil-splash compressor with 6.5 hp Honda engine for superior performance. Benefits • Twin air tanks for even weight distribution with 8.O gallon capacity • Idle control allows engine to run at low RPM • 12.4 cfm @ 4O psi 1O.4 cfm @ 1OO psi Applications Framing and Sheat

psi; 8.9 cfm @ 100 psi Applications Framing and Sheathing, Roofing and Decking Contractor Series PC2013 2.0 hp Wheelbarrow Oil-Splash Compressor Powerful wheelbarrow oil-splash compressor with 20 hp motor for superior performance. Benefits • Durable cast iron cylinder for extended wear • Dual control for constant run or on/off operations • 8.5 cfm @ 40 psi 7.2 cfm @ 100 psi Applications Framing and Sheathing, Roofing and Decking Contractor Series Compressors PC2G14 B.5 hp Hond

Compressors PC2011 1.5 hp Electric Wheelbarrow Oil-Splash Compressor Powerful 1.5 hp electric oil splash compressor with wheelbarrow design for better portability. Benefits • Durable cast iron cylinder for extended wear • Dual control for constant run or on/off operations • 7.2 cfm @ 40 psi 6.5 cfm @ 100 psi Applications Framing and Sheathing, Roofing and Decking PC2012 5.5 hp Honda® Engine Wheelbarrow Oil-Splash Compressor Powerful wheelbarrow oil splash compressor with 5.5 hp Honda

SaveThisManual For Future Reference. MODEL NOS. 390.262454 390.262553 MODEL NO. 390.262653 I:RI:IF'rSMg N° HYDROGLASS ® HIGH PRESSURE SPRINKLER PUMP • Safety Instructions • Installation • Electrical •Maintenance • Repair Pa_s Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. PRINTED IN U.S.A. Form No. F642-9908 (Rev. 8/18/03) CONTENTS INTRODUCTION INTRODUCTION/XVARRANTY .......................................... 2 Please take a few minutes to read our instructions before you SAFETY ......

3. Fill pump and suction pipe with water. Figure 9 -Run Ten Minutes Or Less If no water is produced within 10 minutes, stop pump, release all pressure, remove priming plug, refill and try again. [AWARNING] Hazardous pressure and risk of explosion and scalding. If pump is run continuously at no flow (that is, with discharge shut off or without priming), water may boil in pump and piping system. Under steam pressure, pipes may rupture, blow off of fittings or blow out of pump ports and scald anyon

A suggested multiple discharge to service is shown in Figure 3. Do not use in a pressure tank or booster pump application. Pump/Piping Installation PUMP INSTALLATION NOTICE: Use Teflon tape supplied with the pump for making all threaded connections to the pump itself. Do not use pipe joint compounds on the pump: they can react with the plastic in the pump components. 1. Bolt pump to solid, level foundation. 2. Support all piping connected to the pump. 3. Wrap 1-1/2 to two layers of Teflon tape c

NOTE: If drain cock valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled. 17. After the water has been drained, close the drain valve. The air compressor can now be stored. 11 — ENG D21245 MAINTENANCE MAINTENANCE UNIT CYCLES AUTOMATICALLY WHEN POWER IS ON. WHEN DOING MAINTENANCE, YOU MAY BE EXPOSED TO VOLTAGE SOURCES, COMPRESSED AIR OR MOVING PARTS. PERSONAL INJURIES CAN OCCUR. BEFORE PERFORMING ANY MAINTENANCE OR REPAIR, UNPLUG THE COMPRESSOR AND

• Safety instructions • Installation & Operation • Maintenance & Storage • Troubleshooting Guide • Parts List • Espa_ol, p. 10 Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. 06/17#2004 Part NO. E100731 TABLE OF CONTENTS Page Warranty ...................... ,................................................................................ see below Safety Instructions ................................................................................................. 1 Important Safety Inst