Install the flare cap with the proper size orifice to match the flow rate desired and open the ^ turn valve. Direct the water flow in to a large container, sink, or floor drain for at least 20 seconds. Read the pressure gauge while the water is flowing. If the gauge maintains 25 PSIG or higher, the water supply is sufficient for the flow rate that was selected. Part Number Stamp Number Orifice Diameter Flow Rate in Gallons Per Hour (GPH) at 25 PSIG 620718954 1 1/8” 100 GPH 620718955 2 3/16” 2

The device is equipped with a quarter turn ball shut off valve and a blank flare cap that permits the determination of Static Water Pressure (not flowing). In addition, there are three orifice flare caps used to determine the Water Flow Rate and Pressure. FIGURE 1 FIGURE 2 Connection: Shut off water coming from the back room. Connect the water supply line using the applicable adapter fitting (not supplied) to the 1/2” ID pigtail on the water flow device. Turn off ^ turn valve before turning

After connected, proceed with the following. Static Pressure Check: Place the flare gasket and blank flare cap on the device. Open ^ turn valve and read pressure gauge. If pressure reads below 25 PSIG there is no need to go any further. Correct the supply problem before proceeding. If the pressure exceeds 60 PSIG we recommend a water pressure regulator be installed. Flowing Pressure Check: Estimate the water usage of all equipment connected to the water delivery system (e.g. IntelliCarb = 12

45098) V\ WARNING: TDisconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all power is off to the unit before performing any work. Failure to comply could result in serious injury, death or damage to the equipment. Perform the following procedure to remove the platform (See Figure 1.): 1. Remove the concentrate container from the dispenser and place it in a refrigerator. 2. Remove the product shelf. 3. Depress the button on t