Appliance Model Serial Number CE Declarations of Conformity: This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical safety (LVD) 72/23/EEC and Electromagnetic interference compatibility (EMC) 289/336/EEC. Parts intended to come into contact with food conform to 89/109/EC. This appliance also conforms to requirements of directive 93/68/EEC. IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DI

Make sure that electrical cords connecting other appliance do not come into contact with the hob top. Before disposing of an unwanted appliance, it is recommended that it is made inoperative and that all potentially hazardous parts are removed. Using your hob HVC60 Zones: 1. Front left 1.2 kW 140 mm 2. Rear left 2.3 kW 210 mm 3. Rear right 0.75/2.2 kW 120/210 mm dual 4. Front right 1.2 kW 140 mm Control panel: 5. Front left zone control 6. Rear left zone control 7. Rear right zone control 8. Fro

Accumulated baked-on stains/ dirt, sugar spills or melted plastics Cleaning sponge or glass scraper and soft cloth Wipe over the zone to be cleaned with a sponge and hot water, using a ceramic scraper to remove any large marks or stains and then wipe off with a soft dry cloth. Rings and hard water residues White vinegar and soft cloth Pour a small amount of warm white vinegar onto the stain, leave it to stand, and then wipe off with a soft dry cloth. 7Care and Maintenance Always disconnect the a

Pleasekeepthebooklethandy.Youmaywishtorefertoitatalaterdate. CDA Important: This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and there- fore should not be used in a commercial environment. The appliance guarantee will be void if the appliance is used within a non domes- tic environment i.e. a semi commercial, commercial or communal environment. Contents Model RC 9301 .. Page Number Introduction .

Attention: Do not store flammable material in the oven, or the storage compartment. 26 Removal of the Inner Glass Door Panel – The inner glass door panel can easily be removed for cleaning by unscrewing the four screws (fig. 25). – When re-assembly ensure that the inner glass is correctly positioned and do not over tighten the screws. Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the g

Grilling and “Au Gratin” Grilling may be done without the roasting jack on position of the switch, because the hot air completely envelops the food that is to be cooked. Set the thermostat to position 175 °C and after having preheated the oven, simply place the food on the rack. Close the door and let the oven operate with the thermostat on position 175 °C, until grilling is done. Adding a few dabs of butter before the end of the cooking time gives the golden “au gratin” effect. Grilling with th

RV 900 .. mod. RV 1000 .. Fig. 35b Conversion to Natural Gas or to LPG Conversion to Natural Gas or to LPG Injectors replacement of top burners Every cooker is provided with a set of injectors for the various types of gas. Injectors not supplied can be obtained from the After-Sales Service. Select the injectors to be replaced according to the table at page 47. The nozzle diameters, expressed in hundredths of a millimetre, are marked on the body of each injector. To replace the injectors proceed

• Do not cover the grilling grid with aluminium-foil. • Do not use the oven tray for roasting. • Do not place hot enamel parts in water. Leave them to cool first. • Do not allow vinegar, coffee, milk, saltwater, lemon or tomato juice to remain in contact with enamel parts (inside the oven and on the oven tray). • Do not use abrasive cleaners or powders that will scratch the surface of the stainless steel and the enamel. • Do not attempt to repair the internal workings of your cooker. • Do remove

– Put the meat to be cooked onto the rod, being careful to secure it in the center with the special forks. – Insert the rod into the motor opening and rest it onto the support of the spit collar; then remove the grip by turning it to the left. The rotation direction of the rotisserie can be either clockwise or counter-clockwise. Fig. 17 – Insert the dripping pan into the lowest rack holders of the oven and insert the rod support into the intermediate rack holders. – Put the meat to be cooked ont

If your local gas supply makes it difficult to light the burner with the knob set to maximum, set the knob to minimum and repeat the operation. Choice of burner The burner must be chosen according to the diameter of the pans and energy required. Burners Pan diameter Fig. 6 Auxiliary 12 . 14 cm Semi-rapid 16 . 24 cm Rapid 24 . 26 cm Triple-ring 26 . 28 cm Wok max 36 cm do not use pans with concave or convex bases Saucepans with handles that are excessively heavy in relation to the weight of the p