To prevent air from leaking out of the tank between uses, turn the RED ON/OFF KNOB clockwise to the closed position. Storage STORING YOUR PORTABLE AIR TANK Turn the RED ON/OFF KNOB CLOCKWISE to the OFF position when storing your air tank. Failure to remove condensation will cause the tank to rust prematurely. Always drain the tank of all air after the last use for the day and before repairing or removing any component parts. Point the safety pressure relief valve AWAY FROM YOUR BODY when releasi

If this Portable Air Tank is used for commercial or rental purposes, this warranty applies for only 90 days from the date of purchase. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Sears, Roebuck and Co., Dept. 817WA, Hoffman Estates, IL 60179 Important Safety Instructions and Guidelines The information listed below should be read and understood by the operator. This information is given to protect the user while operating and st

operations • 8.5 cfm @ 40 psi 7.2 cfm @ 100 psi Applications Framing and Sheathing, Roofing and Decking Contractor Series Compressors PC2G14 B.5 hp Honda® Engine Wheelbarrow Oil-Splash Compressor Powerful wheelbarrow oil-splash compressor with 6.5 hp Honda engine for superior performance. Benefits • Twin air tanks for even weight distribution with 8.O gallon capacity • Idle control allows engine to run at low RPM • 12.4 cfm @ 4O psi 1O.4 cfm @ 1OO psi Applications Framing and Sheat

Compressors PC2011 1.5 hp Electric Wheelbarrow Oil-Splash Compressor Powerful 1.5 hp electric oil splash compressor with wheelbarrow design for better portability. Benefits • Durable cast iron cylinder for extended wear • Dual control for constant run or on/off operations • 7.2 cfm @ 40 psi 6.5 cfm @ 100 psi Applications Framing and Sheathing, Roofing and Decking PC2012 5.5 hp Honda® Engine Wheelbarrow Oil-Splash Compressor Powerful wheelbarrow oil splash compressor with 5.5 hp Honda

psi; 8.9 cfm @ 100 psi Applications Framing and Sheathing, Roofing and Decking Contractor Series PC2013 2.0 hp Wheelbarrow Oil-Splash Compressor Powerful wheelbarrow oil-splash compressor with 20 hp motor for superior performance. Benefits • Durable cast iron cylinder for extended wear • Dual control for constant run or on/off operations • 8.5 cfm @ 40 psi 7.2 cfm @ 100 psi Applications Framing and Sheathing, Roofing and Decking Contractor Series Compressors PC2G14 B.5 hp Hond

Parts List • Espaflol, p. 10 Estates, IL 60179 U.S.A. TABLE OF CONTENTS Page Warranty .................................................................................... see below Safety Instructions........................................................................ 1 ImportantSafety Instructions& Guldef=ne_......................................... 1 Spec_ffcabol18....................................................................................... 2 (31os._'y-. .........................

The following schedule is geared toward a consumer whose compressor is used in a normal working environment on a daily basis. If necessary, the schedule should be modified to suit the conditions under which your compressor is used. The modifications will depend upon the hours of operation and the working environment. Air compressors used in an extremely dirty and/or hostile environment will require a greater frequency of all maintenance checks. Oil Changing For changing the pump oil, be sure to

A suggested multiple discharge to service is shown in Figure 3. Do not use in a pressure tank or booster pump application. Pump/Piping Installation PUMP INSTALLATION NOTICE: Use Teflon tape supplied with the pump for making all threaded connections to the pump itself. Do not use pipe joint compounds on the pump: they can react with the plastic in the pump components. 1. Bolt pump to solid, level foundation. 2. Support all piping connected to the pump. 3. Wrap 1-1/2 to two layers of Teflon tape c

3. Fill pump and suction pipe with water. Figure 9 -Run Ten Minutes Or Less If no water is produced within 10 minutes, stop pump, release all pressure, remove priming plug, refill and try again. [AWARNING] Hazardous pressure and risk of explosion and scalding. If pump is run continuously at no flow (that is, with discharge shut off or without priming), water may boil in pump and piping system. Under steam pressure, pipes may rupture, blow off of fittings or blow out of pump ports and scald anyon

SaveThisManual For Future Reference. MODEL NOS. 390.262454 390.262553 MODEL NO. 390.262653 I:RI:IF'rSMg N° HYDROGLASS ® HIGH PRESSURE SPRINKLER PUMP • Safety Instructions • Installation • Electrical •Maintenance • Repair Pa_s Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. PRINTED IN U.S.A. Form No. F642-9908 (Rev. 8/18/03) CONTENTS INTRODUCTION INTRODUCTION/XVARRANTY .......................................... 2 Please take a few minutes to read our instructions before you SAFETY ......