1 FEATURES AND FUNCTIONS .............................. 2 NAME OF PARTS ................................................... 3 PREPARATION ....................................................... 5 OPERATION ........................................................... 6 TIMER OPERATION ............................................... 8 SLEEP TIMER OPERATION ................................... 9 MANUAL AUTO OPERATION ............................... 9 ADJUSTING THE DIRECTION OF AIR CIRCULATION .......

The fan may operate at very low speed during Dry operation or when the unit is monitoring the room’s temperature. During SUPER QUIET operation, the fan will operate at very low speed. In the monitor AUTO operation, the fan will operate at very low speed. During Heating operation, water may be produced from the outdoor unit due to Automatic Defrosting operation. After approximately 400 hours of Air Cleaning Mode use, the AIR CLEAN Indicator Lamp will begin to flash slowly (as shown in the fi

6. Install the air filter. Please consult instructions for cleaning the air filter on page 12. 7. Close the intake grille. Push the intake grill in at 4 points (the two ends of its lower side as well as two center points of the lower side, as shown in the figure) to close it. If, after cleaning the dust collection unit, the operation indicator lamp and the timer indicator lamp flash during Air Cleaning, please ensure that the unit is not damp and that the intake grille is properly closed. If,

Be sure the Intake Grille (Fig. 4 9) is installed securely. When removing and replacing the air filters, be sure not to touch the heat exchanger, as personal injury may result. CAUTION! Cleaning the Air Filter 1. Open the Intake Grille, and remove the air filter. Lift up the air filter’s handle, disconnect the two lower tabs, and pull out. 2. Remove dust with a vacuum cleaner or by washing. After washing, allow to dry thoroughly in a shaded place. 3. Replace the Air Filter and close the Intake

. . ( . . ™ _ ) + . •§ ¶ ‡ fi ‹ . Y # @ fl › ¤ K ° . J H G I 5 6 4 7 8 OPERA TION TIMER AIR CLEAN COIL DR Y = A B D C 9 3 1 2 Fig. 5 Fig. 1 Fig. 4 Fig. 3 Fig. 2 Fig. 7 To facilitate explanation, the acompan ying illustra- in taioctnu ahla os pbeereanti odnra, whonw toe vsehrow al posible indicators; , the display wil only show those indicators apropriate to the curent op- eration. Fig. 6 SAFECTYO PRNECTAEUTNIOTNSS En-1 FEA TURES AND FUNCTIONS . En-2 NAME OF P A RT S En-3 PREP ARA TION En-4 OPER

When used for extended periods, the unit may accumulate dirt inside, reducing its performance. We recommend that the unit be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service personnel. . When cleaning the unit’s body, do not use water hotter than 104 °F, harsh abrasive cleansers, or volatile agents like benzene or thinner. Do not expose the unit body to liquid insecticides or hairsprays. . When shutting down the unit for one month

En-1 ADJUSTING THE FEATURES AND FUNCTIONS ........................... En-2 AIR CIRCULATION .............................................. En- 9 NAME OF PARTS ................................................ En-3 SWING OPERATION ......................................... En-10 PREPARATION .................................................... En-4 COIL DRY OPERATION ..................................... En-10 OPERATION ........................................................ En-5 MANUAL AUTO OPERATI

. . . . . . .2, 3 Operating Instructions . . . . . .4, 5 Additional Controls . . . . . . . . . . .5 Controls . . . . . . . . . . . . . . . . . . . .4 Normal Operating Sounds . . . . .5 Care and Cleaning Air Filter . . . . . . . . . . . . . . . . . . .6 Grille and Case . . . . . . . . . . . . . .6 Grille Frame Removal . . . . . . . . .6 Outdoor Coils . . . . . . . . . . . . . . .6 Installation Instructions Through-the-Wall Installation—Optional . . . . . . . .13 Window Installation . . . . . . .

. If dirt is allowed to accumulate on the air filter, air flow will be reduced, lowering operating efficiency and increasing noise. . During periods of normal use, the air filters should be cleaned every two months. ERRORS AND SELF DIAGNOSIS TIMER MODE ZONE START/STOP CLOCK ADJUST SET TIME TEMP./DAY FAN CONTROL MASTER CONTROL DAY OFF ENERGY SAVE Error Code If there is a problem with the air conditioner, it will stop running and “E: EE” will be displayed instead of the clock. (1) If the operation

^ : Use to advance the day forward. Ў : Use to turn the day back. TIMER MODE SET ZONE START/STOP CLOCK ADJUST SET TIME TEMP./DAY FAN CONTROL MASTER CONTROL TIMER DAYWEEKLY ON OFF1COOL 1 2 3 ”. DAY CODE 1 2 3 4 5 6 7 DAY OF THE WEEK MON TUE WED THU FRI SAT SUN 3 3 Hold the SET button down for 3 seconds. The “WEEKLY 1” ON time starts flashing, and the fan speed and operating mode displays go off. 4 4 Press the SET TIME button to set the day’s first ON time. ^ : Use to advance the time forward. Ў :