The air filter should be cleaned once a month. More frequent cleaning may be necessary depending on outdoor and indoor air quality. Air Filter Removal The air filter on the above models is located behind the Air Inlet Grille. To remove the air filter, grasp the filter handle located on the up side of the Air Inlet Grille and elide the air filter to the up. To reinstall the air filter, reverse the above procedure. ik CAUTION ik DO NOT forget to install the air filter. If the air conditioner

Please read this "Use and Care Manual" carefully before installing and using this appliance. Keep this manual for future reference. Muchase gracias por comprar un aire acondicionado Admirar Lea atentamente el “Manual de Uso y Mantenim ento” antes de instalar y utilizar este producto. Conserve este manual para consultarlo en el futuro. For Service Cali 1 877 465 3566 Para obtener servicio técnico, llame al 1 877 465 3566 TABLE OF CONTENTS Page Air Conditioner Safety.........................

—SAVE THESE INSTRUCTIONS — 4 WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 7 INSTALLATION REQUIREMENTS • The portable air conditioner should be connected to a 115 V, 60 Hz, 15- or 20-amp fused 3-prong grounded outlet. • The use of a time-delay fuse or time-delay circuit breaker is recommended. • All wiring must comply with local and national electrical codes and be installed by a qualified electrician. If you have any questions, contact a qualified electrician. Electrical Requirements ELECTRIC S

When outdoor temperature is approximately 65 F or below, frost may form when unit is in cooling mode. Switch unit to FAN (only) operation until frost melts. Remove and clean filter. PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTION Air conditioner will not operate Inefficient or no cooling Noisy unit Odors Water dripping outside Water dripping inside Ice or frost build-up Low outside temperature. Unit air filter is dirty. Unit is not properly angled to allow water to drain outside. Unit must be installe

NOTE: Temperature setting range is from 19°C (66°F) to 31°C (88°F). Above LED lights on when the relevant mode is in use. WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 14 WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 15 OPERATING INSTRUCTIONS .REMOTE CONTROL 12347 Power Mode +_ Temp/Time Auto Power Saver Mid High Low Timer Fan Speed 1238568456799 Power BUTTON The appliance will be started when it is energized or will be stopped when it is in operation, if you press this button. Mode BUTTON Used

WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 16 WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 17 CARE AND MAINTENANCE When servicing the air conditioner, be sure to turn the mode switch to the "OFF" position and disconnect the power cord from the electrical outlet. 1. DO NOT use gasoline, benzine, thinner or other chemicals on the air conditioner as these substances may cause damage to the paint finish and deformation of plastic parts. 2. Never attempt to pour water directly in front of the uni

Above LED lights on when the relevant mode is in used. Mode Timer Airconditioner F h High fan speed Medium fan speed Low fan speed Auto fan speed Cooling Fan only Display set temp Display set timer Timer Energy-saving Indication symbols of LED on control panel : Fan Speed button Used to select fan speed in sequence auto, low, medium and high (low and medium are in same fan speed). Timer button Used to set or cancel timer operation. When the unit is in operation, you can set OFF TIMER. When the u

When using THERMOSTAT, be sure to allow three minutes before changing temperature. Adjusting too quickly may cause an overload resulting in a blown fuse. ! CAUTION ! MODE Fig.9 The mode knob controls fan speeds and cooling speeds. To set desired cooling temperature, simply rotate the mode knob dial to the appropriate setting. See Fig. 9. LOW FAN will circulate the air at a minimum speed without cooling. HIGH FAN will circulate the air at a maximum speed without cooling. LOW COOL provides cooling

Keep this manual for future reference. Muchase gracias por comprar un aire acondicionado Admiral®. Lea atentamente el “Manual de Uso y Mantenimiento” antes de instalar y utilizar este producto. Conserve este manual para consultarlo en el futuro. For Service Call 1 877 465 3566 Para obtener servicio tecnico, llame al 1 877 465 3566 ROOM AIR CONDITIONER Use and Care Manual AIRE ACONDICIONADO PARA HABITACIONES Manual de Uso y Mantenimiento WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 1 WAC 5 6 8 U

To test your power supply cord: 1. Plug power supply cord into a grounded 3-prong outlet. 2. Press RESET. 3. Press TEST (listen for click; Reset button will trip and pop out). 4. Press and release RESET (listen for click; Reset button will latch and remain in).The power supply cord is ready for operation. NOTES: • The Reset button must be pushed in for proper operation. • The power supply cord must be replaced if it fails to trip when the test button is pressed or fails to rest. • Do not use the