Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: Electrolux Dateigröße: 808.74 kb Dateiname: Unterrichtssprache:

The lamp (LT) will continue to flash until the nominal cookingtemperature is reached. It then stays on permanently. When illuminated, this lamp (LV) indicates that steam condensation is switched on. When cooking is completed, steam condensation will start automatically and will remain in operationuntil the pressure in the appliance has been reduced to normal. The lamp (LV) will flash during the cooling phase. 4.4 Shutting down An acoustic signal sounds when cooking is over. This is acknowledged by pressing the button (Q). The power supply is then switched off. All activated functions are subsequently switched off: • Press the pre-set temperature button (TT) for some seconds. Lamp (LT) extinguishes. • Press the cooking time button (DT). Lamp (LD) extinguishes. • Press the starting time button (ZT). Lamp (LZ) extinguishes. (Starting-time programme exists as an option) • Press the button for steam condensation (V). The lamp (LV) will extinguish. • Switch off the Soft button (R), if this was activated. • Switch off the control switch (S). Turn from position I to 0. Lamp (LS) extinguishes. • Switch off the power isolator (H) (only available as anoption). • Turn from position I to 0. 0 = Off After cooking has been completed, the control switch (S) isswitched off. Page 6 62.9696.01 OPERATING INSTRUCTIONS • Turn from position I to 0. 0 = Off • The lamp (LS) extinguishes. • Switch off the power isolator (H) (only available as an option). Turn from position I to 0. 0 = Off The appliance can be switched off before cooking has beencompleted. If the function buttons (TT), (DT) and (ZT) are switched on andswitching off is only done by means of the control switch (S), all the functions and previously set data for temperature, cooking time and starting time remain saved and active when theswitch (S) is turned on again. If the appliance develops a fault, the electrical switch in thebuilding must also be switched off. 4.5 Additional functions SOFT Pressing the Soft button (R) adapts the power supply to thefood, i.e. reduces it. The lamp (LR) on the button (R) lights up if the soft setting hasbeen switched on. The following functions are activated by pressing button (Q): 1. All displays Food temperature (AT) Cooking time (AD)Starting time (AZ) flash indicating the nominal value that has been programmed in. 2. Acknowledgement of the acoustic signal when cooking hasbeen completed. 3. Acknowledgement of error messages (see section 12, Troubleshooting). ZT Button, starting time LZ Lamp, starting time LR Lamp, soft settings Q Button, acoustic signal R Button, soft Fig. 3 Right console Cooking using the SOFT setting Normally (Soft setting deactivated), the food is heated up atmaximum power and in the shortest possible heating-up time. This method of operation is suited to food with a high watercontent and which has good heat conductivity properties. When maximum power is used to heat them up, viscous, pastyand difficult to heat food (dairy products) tends to dry out alon...

Herunterladen

Geben Sie zwei Ziffern: