Some illustrations in this Instruction Manual may show details or attachments that differ from those on your own power tool NAME OF PARTS: (Fig. 1a) (Fig. 1b) SPECIFICATIONS: 3 1/4-INCH BELT SANDER ET-3303-J: Motor Single-Phase, Series: Wound Commutator Motor Power Source Single-Phase 115V AC/DC 60Hz Sanding Belt Size 3”x21” (76mmx533mm) Input 950W No-Load High 1475ft/min (450m/min) Belt Speed Low 1180ft/min (360m/min) Weight 10.8 lbs. (4.9kg) 3 1/4-Inch Belt Sander Operator's Manual Operation A

Therefore, either the symbol “ ” or the words “Double insulation” appear on the power tool or on the nameplate. Although this system has no external grounding, you must still follow the normal electrical safety precautions given in this Instruction Manual, including not using the power tool in wet environments. To keep the double insulation system effective, follow these precautions: a. Only a AUTHORIZED JOHN DEERE DEALER should disassemble or assemble this power tool, and only genuine JOHN DEER

WARNING: DO NOT PRESS THE GRINDER FORCIBLY AGAINST THE SURFACE TO BE GROUND. HEAVY PRESSURE CAN RESULT IN WHEEL BREAKAGE AND SERIOUS INJURY. IT CAN ALSO DAMAGE THE SURFACE BEING GROUND OR DAMAGE THE GRINDER’S MOTOR. 4. Use proper grinding angle. Grind only with the wheel’s edge by lifting the grinder 15° to 30°, as shown in Fig. 2. CAUTION: DO NOT USE THE ENTIRE SURFACE OF THE DEPRESSED CENTER WHEEL. USE ONLY THE EDGE OF THE DEPRESSED CENTER WHEEL. 4 1/4-Inch Disc Grinder Operator's Manual Opera

Each component has been rigorously tested to ensure the highest level of acceptance. John Deere 8-Inch Vertical Polisher and sander features a built-in regulator for speed control and through handle exhaust which vents air away from work surface. Includes polishing bonnet, sander, backing plate and wrench. This operator's manual was compiled for your benefit. By reading and following the simple safety, installation, operation, maintenance and troubleshooting steps described in this manual, you w

Prompt Disposition. John Deere will make a good faith effort for prompt correction or other adjustment with respect to any product which proves to be defective within limited warranty. For any product believed to be defective within limited warranty, first write or call dealer from whom the product was purchased. Dealer will give additional directions. If unable to resolve satisfactorily, write to the Mi-T-M® Corporation at address below, giving dealer’s name, address, date, and number of dealer

USE ACCESSORIES RATED AT TOOL RPM OR HIGHER Always use grinding wheels with an RPM rating that meets or exceeds the tool RPM rating. Always examine wheels for chips, cracks or signs of damage before mounting. Never use grinding wheels that have been dropped or exposed to: water, solvent or extreme temperature changes. The grinder’s speed should be checked with a tachometer before mounting a wheel; after all repairs and whenever the grinder is issued for use. 1/4-Inch Right Angle Grinder Operator

The lubricator is properly set when a light stain of oil collects on the paper. Excessive amounts of oil should be avoided. In the event that it becomes necessary to store the tool for an extended period of time (overnight, weekend, etc.), it should receive a generous amount of lubrication at that time. The tool should be run for approximately 30 seconds to ensure oil has been evenly distributed throughout the tool. The tool should be stored in a clean and dry environment. Recommended lubricants