Stimmen - 3, Durchschnittliche Bewertung: 3.7 ( )

Hersteller: Monessen Hearth Dateigröße: 2.89 mb Dateiname: Unterrichtssprache:

• Install volcanic stone and glowing embers BEFORE installing logs. • To prevent sooting, make sure logs do not cover any burner openings. SLBV firebox Accessories/Parts Cat. No. Model No. description H7245 — SLBV-40 Log Set Assembly 88L53 fGE Bag of Glowing Embers (Rockwool) 80L42 fdVS Bag of decorative Volcanic Stone Step 2 Align hole at the bottom of left front log (2) over the left front brackets and the right front log over the right front brackets. 32 1 Align the hole at the bottom of log (5) over the "Nub" of log (3) as shown. 3 5 Step 4 Figure 24 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. SUPERIOR® B-VENT GAS FIREPLACES • MODELS SLBV-35, SLBV-40 • INSTALLATION INSTRUCTIONS Only doors certified with the appliance shall be used. Seules des portes certifiees pour cet appareil doivent etre utilisees. CAUTION: DO NOT abuse glass enclosure panel by striking or slamming shut. Installing the Glass Enclosure Panel 1. Refer to Figure 25. Position the glass enclosure panel in front of the firebox opening, with the bottom of the enclosure panel held away from the fireplace. Hook the top flange of the enclosure panel frame over the top of the firebox frame. 2. Gently move the bottom of the enclosure panel frame toward the fireplace, ensuring that the gasket seats evenly. Fasten the two latches under the firebox floor to the vee-flange on the enclosure panel. Close both latches securely. WARNING • Do not attempt to substitute the materials used on these doors, or replace cracked or broken glass. • Handle this glass with extreme care! Glass is susceptible to damage – D o not scratch or handle roughly while reinstalling the glass door frame. • The glass door(s) of this appliance must only be replaced as a complete unit as provided by the manufacturer. Do not attempt to replace broken, cracked or chipped glass separately. • Do not attempt to touch the front enclosure glass with your hands while the fireplace is in use. WARNING Do not operate appliance with the glass front removed, cracked or broken. AVERTISSEMENT Ne pas utiliser l'appareil si le panneau frontal en verre n'est pas en place, est craque ou brise. 3. Install the hood. Note the location of the three clips inside the top air channel above the glass enclosure panel. The clips are equally spaced on the top surface of the air channel opening. If needed, use a screwdriver to open the clips slightly. Engage the back edge of the hood into the clips to secure. Removing the Glass Enclosure Panel 1. Refer to Figure 25. To access the spring latches securing the front glass enclosure panel, open the lower control compartment door by lifting and pulling the bottom panel forward. 2. Pull the spring latches forward and down to release them from the lower door channel. 3. Pull the bottom of the glass enclosure panel out a few inches, and grasp it on the right and left sides. Gently lift to release the panel from its upper channel, and then pull the enclosure panel forward to remove it. 4. Visually inspe...

Herunterladen

Geben Sie zwei Ziffern: