Stimmen - 0, Durchschnittliche Bewertung: 5 ( )

Hersteller: Garland Dateigröße: 2.82 mb Dateiname: L0211265.pdf Unterrichtssprache:

4. Replace the door mounting screws (See A in illustration). 5. If the door is not in line with the oven frame, remove it and repeat the above steps. 33 General Care & Cleaning FEATURE OVERVIEW Removing & Replacing Warmer Drawer To Remove and Replace Warmer (Warm & Ready TM) Drawer Pull up with finger To Remove Warmer Drawer: 1. r_ _ Turn power off before removing the warmer drawer. 2. Open the drawer to the fully opened position. 3. On the right glide you wilt find a shield attached with a hex-head screw (see figure 1). Using a 1/4" socket and ratchet remove the shield. 4. Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever. 5. Pull the drawer away from the range. Removeshieldonri To Replace Warmer Drawer: glide. Pullup onleftlever while pushingdownon 1. Replace shield on the right glide of the drawer body. 2. Pull the bearing glides to the front of the chassis glide (see figure 2). 3. Align the glide on each side of the drawer with the glide slots on the range. 4. Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated Figure 1 remove the drawer and repeat steps 2-4. This will minimize possible damage to the bearing glides. Figure 2 Oven Lights FEATURE OVERVIEW Operating Oven Lights Replacing Oven Light _'IVJV-'1;t#ll_?[_lElectrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer. Be sure the range is unplugged and all parts are COOL before replacing oven light(s). Wear a leather-faced glove for protection against possible broken glass. To Operate the Oven Lights Both of the interior oven lights automatically turn on when the oven door is opened. Press @ to turn the lights ON and OFF when the oven door is closed. Each oven light is located at the rear wall of the oven interior and is covered with a glass shield held by a wire holder (See Figure 3). The Glass Shields must be in place whenever the oven is in use. To Replace the Oven Light: 1. Turn electrical power off at the main source and unplug the range. 2. Press Wire Holder to one side to release the glass shield. 3. Replace the old bulb with a new 40 watt appliance bulb. 4. Replace Glass Shield over bulb and snap Wire Holder into place. 5. Turn power back on again at the main source (or plug in the range). 6. The clock will then need to be reset. To reset, see Setting the Clock in this Use & Care Guide. Figure 3 34 Before You Call Solutions to Common Problems Before you call for service, review this list. It may save you time and expense. that are not the result of defective workmanship or materials in this appliance. The list includes common occurrences OCCURRENCE Range is not level. POSSIBLE CAUSE/SOLUTION Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at base of range until the rack is level. When range is level, cooktop ...

Herunterladen

Geben Sie zwei Ziffern: