Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
1.
To remove magazines in the IE load port, pull
3.
Make sure the barcode label of the magazine is
each magazine out horizontally.
clean. Clean it if necessary.
2.
To remove all other magazines, push each
4.
Replace any cartridges in the same slots from
magazine upwards until it unsnaps, then pull it
which they were removed.
out.
5.
Close the access door.
NOTE:
All magazines in the column
above this magazine must be removed first.
Prepare the library for use
1.
On the operator panel, press the Robotics Enabled
button to enable the picker assembly.
Install the new magazine
2.
Run the Configure and Calibrate teach test. See
1.
If the magazine is being installed in an IE load
HP StoreEver Enterprise Systems Library (ESL) G3
port:
Tape Library User Guide, Teaching the Library
a.
Insert the magazine in the appropriate space,
(Configuration and Calibration) section.
making sure the barcode label is at the top.
3.
If the magazine is new (not a replacement) and
it should be part of a partition, modify the
partition to include it. See HP StoreEver Enterprise
Systems Library (ESL) G3 Tape Library User
Guide, Modifying Partitions section.
HP web sites
For additional information, see these HP web sites:
•
http://www.hp.com
•
http://www.hp.com/go/storage
•
http://www.hp.com/service_locator
•
http://www.hp.com/support/manuals
b.
Push in until the magazine is properly seated.
2.
If the magazine is being installed in any location
other than an IE load port:
NOTE:
Magazines must be installed in a
bottom-to-top order. For example, you must
install a magazine in column 3, section 3
before you can install magazines located
in column 3, sections 2, then 1.
a.
Insert the magazine in the appropriate space,
making sure the hooking tabs align with the
anchor slots and the barcode label is at the
top.
b.
Using both hands, gently push the magazine
downward until it snaps into place.
c.
Make sure that all four tabs are fully engaged
and that the back of the magazine is flush
with the wall of the module.
Page 2
...Dieses Handbuch ist für folgende Modelle:
Media Storage - HP StoreEver ESL G3 300 slot Tape Library (130.57 kb)
Media Storage - HP StoreEver ESL G3 700 slot Tape Library (130.57 kb)
Media Storage - HP StoreEver ESL G3 1500 slot Tape Library (130.57 kb)
Media Storage - HP StoreEver ESL G3 3000 slot Tape Library (130.57 kb)