Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
4.
Remove the air filter by sliding it to the right and
pulling it out of the module door.
Remove the existing air filter
1.
Locate the retaining bar across the air filter to be
CAUTION:
The library can be brought
removed.
back online without the air filter in place,
if necessary. If an IEM board is attached
to the retaining bar, the retaining bar and
IEM board must be reinstalled before any
library operation. Do not operate the
library for more than a day without the
filter.
Install the new air filter
1.
Insert the replacement air filter in the opening.
2.
Carefully reposition the retaining bar over the
filter.
3.
Use the Phillips screwdriver to tighten the captive
screws.
4.
If there is an IEM board on the retaining bar,
verify that the IEM cables are firmly connected.
CAUTION:
If you are replacing an air
filter at the top of the module door in a
module that contains a 72-slot IE load port,
Prepare the library for use
the Import/Export Manager (IEM) board is
1.
Detach the ESD strap.
attached to the retaining bar. Handle the
2.
Close the access door.
IEM board carefully so that it does not get
3.
On the operator panel, press the Robotics Enabled
damaged and the cables do not get
button to enable the picker assembly.
disconnected.
4.
Return the library to the online state:
a.
From the View menu or in the Managed
Views region of the Operator Control Panel
(OCP), click the name of the physical library.
b.
Click Operations→Change Mode.
Alternatively, in the Managed Views section
of the OCP, click the mode button next to the
name of the physical library. (The button
reads either Online or Offline.)
The Change Library Mode dialog box
appears with the current state of the physical
library shown.
c.
Select the Online button to return the physical
1. Air filter (at top of module door)
2. Retaining bar
library to an online state.
3. Captive Screws
4. IEM board
2.
Use the Phillips screwdriver to unscrew the two
retaining bar captive screws. The screws remain
attached to the retaining bar.
3.
Carefully place the retaining bar on the
magazines directly below the air filter.
Page 2
...Dieses Handbuch ist für folgende Modelle:
Media Storage - HP StoreEver ESL G3 300 slot Tape Library (177.82 kb)
Media Storage - HP StoreEver ESL G3 700 slot Tape Library (177.82 kb)
Media Storage - HP StoreEver ESL G3 1500 slot Tape Library (177.82 kb)
Media Storage - HP StoreEver ESL G3 3000 slot Tape Library (177.82 kb)