Stimmen - , Durchschnittliche Bewertung: ( )

Anleitung Southbend, modell HEAVY DUTY COUNTERLINE HDG-60

Hersteller: Southbend
Dateigröße: 533.21 kb
Dateiname:

Unterrichtssprache:

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

Continue to hold the pilot button for 45 seconds, or until the pilot remains lit. Note that 24" models have one pilot, 36" & 48" models have two pilots, 60" models have three pilots, and 72" models have four pilots. 5. If a pilot is extinguished or the gas supply is interrupted, wait five minutes and repeat the above steps. 6. Allow the pilots to warm-up for 1 minute, then turn all griddle thermostat controls to the “ON” position to check that the pilots will ignite the burners. Figure 5 LeftPilotButtonRightPilot Button(36"&48" Models) LeftPilotRightPilot(36"&48" Models) This drawingshows aModel HDG-36 withthefrontpanels removedtoshowtheinterior parts. Note:24"modelshaveonepilot,36" and48"models havetwopilots,60"models havethreepilots, and 72"models havefourpilots. 60" and72"models havetwo shut-off valves, one in each burner compartment. Grease DrawerMainShut-OffValve OPERATION OF MANUAL GRIDDLE MODELS Each 12"-wide griddle section has a knob on the front panel that directly controls the flow of gas, and so the heat. Turn the knob clockwise to increase the heat; turn it counterclockwise to reduce the heat. After each period of use, allow the griddle surface to cool normally. At the end of each day’s use, turn all control knobs to the “OFF” position. After the griddle has cooled, coat the griddle surface with a light film of cooking oil to protect the surface from moisture. To shut down the appliance for an extended period (or before disconnecting the gas supply), turn all the burner control gas knobs “OFF,” then turn the main gas supply valve(s) to “OFF.” To light the pilots of a manual griddle section, do the following: 1. Turn all griddle controls to the “OFF” position. 2. Light the pilot tube located next to each burner. The pilot flame can be adjusted by turning the screw on the end of the pilot fitting. 3. Turn burner knobs to “HI” position. The burners should have a 1/2" to 5/8" steady blue flame. Adjust if necessary. 4. To turn burners off, turn knob to “OFF” position. Figure 6 LeftPilotRightPilot(36"&48" Models) The drawing belowshows aModel HDG-36-M withthefrontpanels removedtoshowtheinterior parts. Note:24"modelshaveonepilot,36" and48"models havetwopilots,60"models havethreepilots, and 72"models havefourpilots. The pilots can be viewed and lit through openings on thefront panel (Model HDG-36-M shown). OPERATION OF CHARBROILER MODELS Each 6"-wide charbroiler section has a knob on the front panel that directly controls the flow of gas, and so the heat. Turn the knob counterclockwise to increase the heat; turn it clockwise to reduce the heat. To use the charbroiler, turn all the control knobs to the full “ON” position. (If any burners do not light, check the pilots and, if necessary, light the pilots as described later in this section.) After 15 to 20 minutes turn back the flame to maintain enough heat to keep the bottom of the radiants or lava-rock grates hot. The radiants or grates will be at broiling temperature throughout, providing th...