DISCHARGE PIPE SIZES FOR INSTALLATION When the pump is located at a distance from points of water use, it is necessary to increase the discharge pipe size in order to reduce friction loss. The friction loss in a system increases: 1.) As the flow rate increases 2.) As the piping size decreases Consult included Turf Boss performance tables (Appendix III) and friction loss tables (Appendix IV) to determine the amount of head lost for a given application. A. Suction Port Connection (Figure 4) Step 1

INSPECTION Examine the equipment when received. Notify your dealer or carrier of any damage or missing parts. Verify that the equipment is of size and model specified. READ AND FOLLOW SAFETY INSTRUCTIONS This is the safety alert symbol. When you see this symbol on your pump or in this manual, look for one of the following signal words and be alert to the potential for personal injury: DANGER warns about hazards that will cause serious personal injury, death or major property damage if ignored. W

Figure 9 Diffuser Motor Bracket Diffuser Bolt Diffuser Bolt Diaphragm Grommet 8 PARTS FOR TURF BOSS SELF-PRIMING SPRINKLER PUMP Figure Number Description Kit Grouping Identifi er* Repair Part Order Codes by Model Number TB1CI TB15CI TB2CI 1 Plug Kits A 305390901 2 Pump Case B 305491901 3 Grommet C 305392901 G 305396901 305396902 305396903 4 Diaphragm C 305392901 G 305396901 305396902 305396903 5 Fastener Kit* D 305393901 6 Diffuser E 305394901 305394902 305394903 G 305396901 305396902 305396903

WARNING warns about hazards that can cause serious personal injury, death or major property damage if ignored. CAUTION warns about hazards that will or can cause minor personal injury or major property damage if ignored. The label NOTICE indicates special instructions, which are important but not related to hazards. Hazardous voltage. Can shock, burn, or cause death. Ground pump before connecting to power supply. Disconnect power before working on pump, motor or tank. WARNING Carefully read and

Sufficient pipe would be used to prevent this from happening. 3. LOW FLOW OR PRESSURE a) Check suction piping for leaks. b) Check the impeller for clogging. Remove all foreign material if it is clogged. 4. NOISE a) Make sure pump and piping are supported. b) Make sure suction lift does not exceed 20 ft.(6mm) c) Check disch. piping for excessive bends or elbows. d) Check motor bearing for damage. HP Voltage Branch Max. Loads Amperes Fuse Rating Amperes Maximum Length of Cable Size Shown 50’ 100’

REFER TO PRODUCT DATA PLATE(S) FOR ADDITIONAL OPERATING INSTRUCTIONS AND SPECIFICATIONS. CAUTION • Keep work area clean, well-lit and uncluttered. • Keep safety labels clean and in good condition. • Replace missing or damaged safety labels. • Wear safety glasses while installing or performing maintenance on pump. • Adhere to the guidelines of the National Electric Code (NEC) or Canadian Electric Code (CEC), and any other state and local codes for ALL electrical installations. Check with the appr

OWNERS MANUAL INSTALLATION • OPERATION • MAINTENANCE 6” & 8” SUBMERSIBLE TURBINE PUMPS BE SURE TO READ OWNER’S MANUAL CAREFULLY BEFORE INSTALLING YOUR PUMP. 6” & 8” SUBMERSIBLE TURBINE PUMPS CONTENTS Inspection-Receipt of Equipment....................................................... Sec. A Equipment and Installation Record................................................. Sec. B General Information........................................................................ Sec. C Suitability of th