3 2. Features ...................................................... 3 3. Names of the Buttons.................................. 4 4. Operations................................................... 4 5. Connections................................................. 7 6. Installation ................................................... 8 7. Troubleshooting........................................... 9 8. Specifications .............................................. 9 This unit has been tested and found

It is designed to fit Clarion monitors (VMA6491, VMA6492 or VMA7191) for rear passenger entertainment. Please follow the directions carefully. Clarion Monitor Headrest Shroud Preparation 1. Remove the headrest from the vehicle. 2. Using scissors, cut along the dotted lines of the provided headrest template. Note: Lay the template on headrest or seatback to verify fit and size. Make sure you verify the fit before proceding to the next step. 3. Lay the template on the headrest or seatback. C

• Please read this owner’s manual in its entirety before operating this equipment. • After reading this manual, keep it handy, such as in your glove compartment. • Save your sales receipt. The warranty at the end of this manual and your sales receipt are essential for warranty service. FCC Approval The Clarion OHM106/156 have been tested and found to comply within the limits of a Class B digital device, pursuant of Part 15 of the FCC rules. These limitations are designed to provide reasonable pr

CONTENTS 1. Key Product Features ...............................................................................................................2 Safety Information.......................................................................................................................3 2. DVD Video Features ..................................................................................................................4 Controls and Functions ......................................................

1. Using a small screwdriver, pry open the transparent battery cover. Coin battery Put the battery into the space provided Push gently in to snap closed Replacing the battery in the remote control 2. Replace the battery with the same type (Model CR2025) and snap the cover closed. Changing the dome lights 1. Using a small straight-edged screwdriver, gently pry the cover away from the light fixture. Opening the light cover 2. Using the same small straight-edged screwdriver, gently remove the light

5. The sole responsibility of Clarion Corporation under this Warranty shall be limited to the repair or replacement thereof, at the sole discretion of Clarion Corporation. 6. If it becomes necessary to send the product or any defective part to Clarion Corporation or an authorized warranty service station, the product must be shipped in its original carton or equivalent carton, fully insured, with shipping charges prepaid. Clarion Corporation will not assume any responsibility for any loss or dam

• Keep drinks and drops from umbrellas away from the set. Water may damage the internal circuitry. • Do not let the set become hot. If temperature in the car is high or the set has been exposed to direct sunlight and is hot, lower the temperature before using it. (The liquid crystal panel will work properly within a temperature range of 14°F - 144° F). • In extremely cold temperatures, the movement of the picture may be slow and the picture may be dark, but this is not a malfunction. The set wil

The initial factory default setting is the RGB input. NOTE: The LED will be green under normal signal input. If no input signal is detected the monitor will display a flashing error message for that particular source. The LED will turn orange upon entering the power saving mode after five seconds. Choose the proper input source by pressing the Input Select Button on the front of the monitor. NOTE: In some cases, if the RGB, Video, or S-Video signal is low, the LED will turn orange and enter a po

Doing so may damage it and voids your warranty. • Keep drinks and drops from umbrellas away from the set. Water may damage the internal circuitry. • Do not let the set become hot. If temperature in the car is high or the set has been exposed to direct sunlight and is hot, lower the temperature before using it. (The liquid crystal panel will work properly within a temperature range of 41° - 104° F.) muaisiuiiiuziu • In extremely cold temperatures, the movement of the picture may be slow and t