Stimmen - 4, Durchschnittliche Bewertung: 4.8 ( )

Hersteller: Stovax Dateigröße: 4.4 mb Dateiname: c99d5d00-26a7-46b6-af22-c158deb57680.pdf Unterrichtssprache:

3. Locate the two (2) latches at the top of the control compartment. To disengage the two latches from the bottom vee-flange of the glass enclosure panel, reach for the handles located towards the back of the latches and pull the handles down toward the front of the appliance. 4. Swing the bottom of the door out and raise it slightly to lift the top flange of the door frame away from the appliance. Installing Glass Enclosure Panel (see Figure 11 ) 1. Visually inspect the gasket on the backside of the glass panel. The gasket surface must be clean, free of irregularities and seated firmly. . Position the glass enclosure panel in front of the firebox opening at a 45 degree angle and engage the top flange over the lip at the top of the firebox opening. See Figure 11. . Swing the glass enclosure panel down and back. Ensure the gasket seats evenly as the panel draws shut. Engage the Vee-flange at the bottom of the panel with the latches and close the latches to secure the panel. 4. Reinstall the control compartment door see installationinstructionson Page4,Reinstalling Control Compartment Door). INSTALL VOLCANIC STONE, GLOWING EMBERS AND LOGS 1. Remove the front glass enclosure panel (see Removing Glass Enclosure Panel on this page). . Carefully remove the log set, embers and volcanic stone from the firebox. Handle logs carefully to prevent breakage. . Install decorative volcanicstone -Mound up a portion of the volcanic stone in front of the burner in a pleasing pattern. 4. Placement of Glowing Embers Separate the Embers (rockwool) into pieces about the size of a quarter (see Figure 12). Keep the pieces fluffed up, not matted. Distribute these pieces over the surface of the burner, as shown in Figure 13 or 14. Do not use more than is necessary. Ensure thatthemainburnerportsremainuncovered by the ember material. Note: This appliance is provided with enough Glowing Embers for several applications, do not use all that is in a new bag at one time. For bestglowingeffect,replacetheembermaterial annually. 5. Placement of Logs - The logs have locating notches or slots to help ensure that they are properly positioned. Proper log placement is critical to prevent sooting. SSBV-3530 -Install as Follows Carefully position the ceramic fiber logs into the firebox as shown in Figure 13. Logs should be placed in the order shown and per the following instructions. 1. Place embers on the front burner tube and volcanic stone in front of the burner as shown and per instructions on this Page (see Placement of Glowing Embers & Install Decorative Volcanic Stone on this Page). . Place the rear log (A) as shown. Position the 2 notches on the bottom of log (A) over the 2 corresponding locating brackets as shown. . Place the center log (C) as shown. The 2 notches on the bottom of log (C) fit over the corresponding locating brackets. 4. Place the left log (B) as shown. The top fork on log (B) fits into the notch on log (A). The bottom of log (B) rests on the subfloor. 5. Place the...

Herunterladen

Geben Sie zwei Ziffern: