Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: Lennox Hearth Dateigröße: 4.4 mb Dateiname: Unterrichtssprache:

5. Always keep the appliance area clear and free from combustible materials, gasoline and other flammable liquids. 6. Remember,Millivoltapplianceshaveacontinuousburningpilotflame. Exercisecautionwhen using products with combustible vapors. OptionalBlowerOFF/ONRockerSwitchSIT Millivolt Gas Valve Gas Outlet Gas Inlet Pilot Adjustment Screw Terminals TPTH,TP & TH Figure 4 HILOWHTPTHTPTPILOTPILOTONtiOFFINOUTOFFONOFFONHI/LO Variable Flame Height Adjustment Manifold Pressure Tap Inlet Pressure Tap Piezo Igniter Main Gas Control Knob OFF/PILOT/ON Piezo Igniter OptionalBurnerOFF/ONRockerSwitch Clean Lower Control Compartment Before re-lighting the fireplace, refer to the lighting instructions in this manual. Instructions are also found on pull-out panels located below the glass door in the control compartment. Honeywell Millivolt Gas Valve Figure 5 ONOFFPILOTLOHIPiezo Igniter OptionalBlowerOFF/ONRockerSwitchOptionalBurnerOFF/ONRockerSwitchHI/LO Variable Flame Height Adjustment Main Gas Control Knob OFF/PILOT/ON Manifold Pressure Tap Piezo Igniter Inlet Pressure Tap Gas Outlet Gas Inlet MAINTENANCE (See Maintenance Schedule, Page20) Refertothemaintenancescheduleformaintenancetasks,procedures,periodicityandbywhomtheyshouldbeperformed.Alwaysverifyproperopera- tionoftheapplianceafterservicing. OFFONOFFON WARNING Turn off gas and electrical power before servicing the appliance. CAUTION Wear gloves and safety Glasses for protection while doing required maintenance. IMPORTANT Always verify proper operation after servicing. NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Keep lower control compartment clean by vacuuming or brushing it out at least twice a year (also clean the air venturi with a brush or wire). More frequent cleaning may be required due to accumulation of lint from carpeting, bedding materials, pet hair, spider webs, etc. It is very important that control compartments, burners, circulating air passageways and air venturi on the appliance are NOT obstructed in any way. Cleaning Glass (see Front Glass Enclosure Panel, Removal and Installation on Pages 7 & 8) Note: Clean glass after first two weeks of operation (after Burn-In period is over) and then only when necessary and when the fireplace is cool. Wipe surface with clean, dampened, soft cloth. Follow with dry, soft towel as desired. Take care not to scratch the glass surface. The viewing glass should be cleaned periodically to remove any build-up caused from the following (on next page): T Do not use abrasive cleaners on glass. Never clean the glass when it is hot. • During start-up, it is normal for condensation to form on the inside of the glass (this condensation and fog will usually disappear in a few minutes). The moisture can cause lint, dust and other airborne particles to cling to the glass surface. • Initial curing of the high temperature paint and burning off of lubricants used in the manufacturing process may result in a film on the glass. • A white coating may form on the glass as a...

Herunterladen

Geben Sie zwei Ziffern: