Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Regency Dateigröße: 598.98 kb Dateiname: Lennox_Hearth_CF_Installation_904538.pdf Unterrichtssprache:

Please read and understand these instructions completely before beginning your installation. This document covers four models of Catalytic Fireplaces. Instructions are provided for all models and many alternative installations for each. Therefore, certain details may not be applicable to your model and may not be required for your application. GENERAL INFORMATION The Catalytic Fireplaces covered in this manual feature ceramic fiber split logs which glow realistically when the heater is operating. The Millivolt appliances covered in this manual are manually controlled and can be incrementally adjusted through a range between High and Low settings. Input of the CF5500 Millivolt appliance is 24,000 BTU/hr maximum modulated to 19,000 BTU/hr at the low flame setting for both natural and propane gas models. Input of the CF6500 Millivolt appliance is 31,000 BTU/hr maximum modulated to 24,000 BTU/hr at the low flame setting for natural gas models. Input for propane gas models is 29,000 BTU/hr maximum modulated to 22,000 BTU/hr at the low flame setting. Both CF5500 and CF6500 models feature a spark ignition system (piezo) that allows the appliances pilot gas to be lit without the use of matches or batteries. This manual systems provides continued service in the event of a power outage. These appliances are fitted with a specially designed pilot oxygen depletion sensor (ODS) which responds to the amount of oxygen available in the room and shuts the appliances off before the oxygen level drops below 18.5%. The pilot can be re-lit only when fresh air is available. Refer to the Combustion and Ventilation Air section. The Catalytic Fireplace Models covered in this manual designed to be built into a framed wall, and finished out with standard construction materials and practices. Inventory Unvented Gas Fireplace Gas connection fittings Installation and Operating Instructions Tools and Building Supplies Normally Required Tools Should Include: Phillips screwdriver Hammer Saw and/or Sabersaw Measuring tape Electric drill and bits Pliers Square Piping complying with local codes Pipe wrench Tee joint Pipe compound Building Supplies Should Include: Framing materials Wall finishing materials Caulking materials (noncombustible) Fireplace surround materials Check the inventory list to be sure that you have all the necessary parts in usable condition. Also check for concealed damage. IMPORTANT SAFETY INFORMATION INSTALLER: PLEASE LEAVE THESE INSTRUCTIONS WITH THE OWNER. OWNER: PLEASE RETAIN THESE INSTRUCTION FOR FUTURE REFERENCE. WARNING: FAILURE TO COMPLY WITH THE INSTALLATION AND OPERATING INSTRUCTIONS PROVIDED IN THIS DOCUMENT WILL RESULT IN AN IMPROPERLY INSTALLED AND OPERATING APPLIANCE, VOIDING ITS WARRANTY. ANY CHANGE TO THIS APPLIANCE AND/OR ITS OPERATING CONTROLS IS DANGEROUS. IMPROPER INSTALLATION OR USE OF THIS APPLIANCE CAN CAUSE SERIOUS INJURY OR DEATH FROM FIRE, BURNS, EXPLOSION OR CARBON MONOXIDE POISONING. Carbon Monoxide Poisoning: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nausea. If you have these signs, obtain fresh air immediately. Turn off the gas supply too the appliance and have it serviced by a qualified professional, as it may not be operating correctly. WARNING: DO NOT USE A BLOWER INSERT, HEAT EXCHANGER INSERT OR OTHER ACCESSORY NOT APPROVED FOR USE WITH THIS HEATER. IMPORTANT: BEFORE STARTING YOUR HEATER INSTALLATION, READ THESE INSTALLATION INSTRUCTIONS CAREFULLY, IN THEIR ENTIRETY TO BE SURE YOU UNDERSTAND THEM COMPLETELY. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD CAUSE AN APPLIANCE MALFUNCTION RESULTING IN SERIOUS INJURY AND/OR PROP...

Herunterladen

Geben Sie zwei Ziffern: