7. Switch the appliance back on. Symptom Possible Cause Remedy Appliance is not switched on Switch on the appliance. Mains plug is not plugged in Insert mains plug. or is loose. Appliance does not work. Check fuse, replace if neces- Fuse has blown or is defective. sary. Mains malfunctions are to be Socket is defective. corrected by an electrician. Turn the temperature control Appliance cools too much. Temperature is set too cold. knob to a warmer setting. Temperature is not properly Please look

If this does not fix the leak, the connection must be reinstalled using a new ferrule and backup ring in the fitting. Contact your Carrier representative for assistance in locating these parts. After leak testing, evacuate, dehydrate, and recharge the circuit using an approved refrigerant recovery device. Correct type and amount of refrigerant are listed on unit nameplate and in base unit documentation. Fig. 2 — Installing Fittings and Valves, 30HX (Typical) 3 Fig. 3 — Installing Valves, 30GX St

Wahrend des normalen Betriebs wird die jeweils im Gefrierschrankherrschende Temperatur (TATSACHLICHE Temperatur) angezeigt. Wahrend des Einstellens der Temperatur wird die zurzeit eingestellteGefrierschranktemperatur (GEWUNSCHTE Temperatur) angezeigt. Inbetriebnahme und Einstellen der Temperatur 1. Stecken Sie den Netzstecker ein. 2. Drucken Sie die Taste "A". Aufgrund der hohen Temperatur blinkt die Alarmleuchte ("M"). Der Summer ertont. 3. Druch Drucken der Taste "L" wird der Summer ausgeschal

FI 55985 and ending with Serial No. G448588. INDEX UNIT FIGURE DESCRIPTION VOLTS UNIT LABEL DIAGRAM 30HR,HS NUMBER 30HR Rev 070 1 WTri ngTor Part-Winding Start All - - 120 2 Suggested Field Wiring Interlocks All All Same As Below 3 '' 4 ‘ ' ‘ "Locations of 070, 080, 090 Control Components Power Schematic 208,230, 460,575 080-1214 080-1224 A 5 Control Li rcu i t (Simplified Schematic) 6 "7 Control Circuit 100, 110, 120 (Simplified Schematic) Power Schematic 208,23

04-53300054-01 Printed in U.S.A. Form 30MP-1SI Pg 1 910 1-10 Replaces: New Installation Instructions CONTENTS Page GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 SAFETY CONSIDERATIONS . . . . . . . . . . . . . . . . . . . 1,2 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-16 Location. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Step 1 — Inspect Shipment . . . . . . . . . . . . . . . . . . .

Tips zur Energie-Einsparung • Das Gerat nicht in der Nahe von Herden, Heizkorpern oder anderen Warmequellen aufstellen. Bei hoher Umgebungstemperatur lauft der Kompressor haufiger und langer. • Ausreichende Be- und Entluftung des Gerates gewahrleisten. Luf-tungsoffnungen niemals abdecken. • Keine warmen Speisen in das Gerat stellen. Warme Speisen erst abkuhlen lassen. • Tur nur so lange wie notig geoffnet lassen. • Die Temperatur nicht kalter als notig einstellen. • Tiefkuhlgut zum Auftauen in d

L. CONTACTS IF AVAILABLE CHILLED WATER COND. PUMP STARTER AUX. CONTACT OR FLOW SWITCH SHOULD BE FLOW SWITCH LOCATED HERE ONLY WHEN COND PUMP STARTER IS INDEPENDENT OF 30HR, HS WIRING. fio~|------0~ - FC i GO—---O— - -0 -0 CONTACTOR COILS FOR COND. FAN MOTORS WITH SEPARATE AIR COOLED COND. FOR EACH REFRIGERATION CIRCUIT. (SEE NOTES 5 AND 6) Fig. 2 — Suggested Field Wiring of Interlocks 0-----©-----0 CONTACTOR COIL FOR COND. WATER PUMP OR FOR FAN MOTOR(S) ON SINGLE TWO CIRCUIT AIR COOLE

30HX-900---009, 30GX-900---005 (50 or 60 Hz — 230-v Control) CONTENTS Page SAFETY CONSIDERATIONS ...................1 INTRODUCTION ..............................1 INSTALLATION ............................. 1-6 Step 1 — Examine Package Contents .........1 Step 2 — Install Piping .......................2 • REMOVE MINIMUM LOAD PORT PLUGS AND INSTALL FITTINGS • INSTALL PIPING • INSTALL BALL AND SOLENOID VALVES • CONNECT PIPING Step 3 — Dehydrate and Recharge Circuit .....3 Step 4 — Install Control W

-If the power cord is damaged, it must be replaced by a certified service agent or qualified service personnel. If the power plug socket is loose, do not insert the power plug. -There is a risk of electric shock or fire. You must not operate the appliance without the lamp cover of the interior lighting. When cleaning, defrosting, taking out frozen food or ice tray do not use sharp, pointed or hard devices, as they can cause damage to the appliance. Be careful not to allow liquids to leak into th

2 — Rigging with Spreader Bars (Field Supplied) Table 2 — Temperature Limits for Standard Units TEMPERATURE F C Maximum Ambient Temperature 125 52 Minimum Ambient Temperature 0 –18 Maximum Cooler EWT* 95 35 Maximum Cooler LWT 70 21 Minimum cooler LWT† 38 3.3 LEGEND EWT — Entering Fluid (Water) Temperature LWT — Leaving Fluid (Water) Temperature *For sustained operation, EWT should not exceed 85 F (29.4 C). †Unit requires modification below this temperature. MOUNTING UNIT — When unit is in proper