When it is selected, it also mutes the acoustic alarm (on some models only). Freezers with door contact rod The acoustic alarm sounds when the door has been left open for more than 1 minute. The alarm stops when the door is closed. If it is necessary to leave the freezer door open for more than 1 minute (e.g. to rearrange food in the drawers), the alarm can be deactivated by pulling the rod (see figure). 16 61433002GB.fm Page 17 Thursday, March 24, 2005 3:23 PM HOW TO USE THE FREEZER Fast freeze

• There is enough ventilation at the side and rear walls. • The temperature of the room is adequate (10oC or above). The appliance is noisy • The appliance is level and stable. • The side and rear walls are clear, and there is nothing resting on the appliance. • The cooling gas in the refrigerator will make a slight bubbling noise, even when the compressor is not running. There is water in the lower part of the refrigerator compartment • The drain hole in the channel at the back of the compartme

• The LED display for the lower zone will flash. • The preset temperature for the upper zone is 10.C / 50. F and for the lower zone is 16.C / 60. F. • To change the temperature display from Fahrenheit to Celsius, or Celsius to Fahrenheit, press and hold the up and down • buttons simultaneously for five seconds. • To view the set temperature in either zone, touch the up or down button at any time and the set temperature will flash in the LED display for five seconds. Optimal temperature selection

As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin. 1 Before first use You must allow the appliance to settle for at least twenty four hours prior to switching the power on. It is recommended that you remove all internal and external packaging and clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm water and then thoroughly dry the interior. The appliance may have a

Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Before scrapping, make the appliance unusable by cutting off the power cable and removing the doors and shelves so that children cannot easily climb inside the appliance. Disposal must be carried out in accordance with local environmental regulations for waste disposal. Deliver the appliance immediately to an authorized dump; do not leave it unattended even for a few day

The minimum space required is: FWC151 – 150 mm wide x 555 mm deep x 825 mm high FWC301 – 300 mm wide x 580 mm deep x 825 mm high FWC601 – 600 mm wide x 580 mm deep x 825 mm high FWC621 – 600 mm wide x 580 mm deep x 825 mm high Please note: When the product is installed, there should be a small ventilation gap between the top of the unit and the underside of the worktop (6 mm or .”) These products should not be installed: 1. In direct sunlight 2. Adjacent to a heat source (oven or radiator) 3. Be

T. (°C) Amb. T. (°F) SN From 10 to 32 From 50 to 90 N From 16 to 32 From 61 to 90 ST From 18 to 38 From 64 to 100 T From 18 to 43 From 64 to 110 • Be careful not to damage the floors when you move the appliance (e.g. parquet flooring). • Do not use mechanical devices or any means other than those recommended by the manufacturer to speed up the defrosting process. • Do not damage the refrigerant circuit. • Do not use electrical appliances inside the freezer compartments, unless such appli

The fridge may have an odour to it at first use. This will disappear as the appliance cools. Please note: • The appliance will work continuously until it comes down to the correct temperature. • If the appliance is switched off, you should allow five minutes before switching it on again to prevent unnecessary damage to the compressor. This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places. • The plug should be fully accessible at all times.

F. • To change the temperature display from Fahrenheit to Celsius, or Celsius to Fahrenheit, press and hold the light button for five seconds. • To view the set temperature, touch the up or down button at any time and the set temperature will flash in the LED display for five seconds. Optimal temperature selection Whilst wine is best stored at temperatures between 13 and 15. C, your wine can also be stored at drinking temperature. For red wine this is between 15 and 17. C, and for white wine bet

• The preset temperature is 12.C / 54. F. • To view the set temperature, touch the up or down button at any time and the set temperature will flash in the LED display for five seconds. Temperature display To change the temperature display from Fahrenheit to Celsius, or Celsius to Fahrenheit, touch the F./C. selection button. Optimal temperature selection Whilst wine is best stored at temperatures between 13 and 15. C, your wine can also be stored at drinking temperature. For red wine this is bet