Stimmen - 3, Durchschnittliche Bewertung: 3.7 ( )

Hersteller: Everpure Dateigröße: 1.17 mb Dateiname: 8b5dee9d-23cf-4c45-a552-554da6d29d60.pdf Unterrichtssprache:

The neutralized or non-acid water then flows into the house water pipes. Because the neutralite does dissolve, you have to add new mineral at least once each year, and sometimes more often (see page 14). TASTE AND ODOR FILTER The taste and odor filter is filled with activated carbon. As water flows into and DOWN through the filter (FIG. 5), the tastes and/or odors are adsorbed and held by the carbon. Water without bad tastes or odors goes into the house pipes. When the activated carbon no longer takes the tastes and/or odors out of the water, you must replace it (see page 16). The carbon usually lasts for up to 1 year, and sometimes longer. It depends on how much water you use, and how much taste and/or odor is in the water. BACKWASH Backwash is a reverse or UPWARD fast flow of water through the filter. The fast, upward flow flushes dirt, sediment, iron, etc., drain. The bed is cleaning. The bed channels water flow mineral. Following backwash, water again changes direction to flow downward through the bed at a fast rate. The mineral bed is repacked and prepared for return to service. FILTERED WATER OUT WATER IN SERVICE BYPASS WATER OUT WATER IN l= Mineral Bed Drain q BACKWASH (25 minutes) FILTERED Mineral WATER OUT WATER Bed IN .Drain from the mineral bed and to the lifted and expanded for good is also mixed to remove any may have formed through the FAST RINSE Ji (5 minutes) 12 SECTION 3 OFYOUR CAR,:R,TER 3A. KEEP THE FILTER FROM FREEZING If the filter is installed where it could freeze (summer with drain hose attached, from the valve. DO cabin, lake home, etc.), you must drain all water NOT LOSE THE BLACK RUBBER FLOW PLUG from it to stop possible freeze damage. To drain the AND RETAINER. filter - n Remove the plastic clips (see key #41, page 26) and pull the adaptors or bypass valve from the • Close the shut-off valve on the house main water inlet and outlet. pipe, near the water meter or pressure tank. = Move the filter close to the floor drain. SLOWLY = Open a faucet in the filtered water pipes to vent and CAREFULLY (the filter is heavy) tip the filter pressure in the filter. over so the valve inlet and outlet are over the drain. Allow water to drain from tank. DO NOT = Looking at FIG. 8 on page 18, move the stem in REST THE FILTER ON THE INLET AND OUT- a single bypass valve to bypass. Close the inlet LET FITTINGS OR THEY WILL BREAK. and outlet valve in a 3-valve bypass system, and open the bypass valve. Tip the bottom of the filter up a few inches and am hold until all water has drained. Leave th_ filter m Unplug the transformer at the wall outlet. laving like this until you are ready to use it. Plug the inlet and outlet with rags to keep dirt, bugs, 5. Pull the holding clip to remove the drain fitting, etc. out. 13 SECTION 3 CARE OF YOUR FILTER I I 3B. ADDING MINERAL.. • NEUTRALIZER FILTER The neutralite mineral is slowly dissolved to neutralize acid in the water (see page 12). If the filter was never serviced, all the mineral would dissolve. How fast it dissolves depends on how much water is used, the pH of the water, and other supply conditions. Add new mineral (see below) about 6 months after installation. Before you add new mineral, use a yard stick or tape rule to measure the distance down to the of the mineral bed (figure 6). If the measurement is 32" or less, over half of the mineral bed remains. You could wait 9 or 10 months before adding mineral the next time. However, if distance to the bed is 38" or more, less than 1/4 of the mineral remains and adding more mineral every 5 months may be better. Use this measurement procedure each time, to adjust your mineral adding interv...

Herunterladen

Geben Sie zwei Ziffern: