Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Sears Dateigröße: 1.17 mb Dateiname: Unterrichtssprache:

2. The display will show a time, but it will be flashing. The timer memory did not keep the time settings and they must be reset, pages 7 and 8. The flashing display is to remind you to reset the timer. NOTE: When power comes on, the flashing display returns to a time of 12:00 AM Sunday, then begins to keep time again. If you do not reset all time settings, the filter will backwash 3 days each week. However, backwash will most likely be on the wrong days and at the wrong time• If the filter was in a backwash when power went off, the valve will return to service position without finishing the cycle• To start another backwash•.. •. use BACKWASH NOW, page 9. 10 SECTION 2 HOW YOUR WATER FILTER WORKS L__ 2B. FILTER APPLICATIONS IMPORTANT: Sears water filters are sometimes installed alone in the water system, but most often other water treating equipment is needed. Always be sure to have your water tested by a qualified testing laboratory. If you need help, ask at your Sears store, or call Sears Water Line, 1-800-426-9345. CLARIFYING FILTER NEUTRALIZER FILTER A Sears Clarifying Filter takes sediments such as dirt, All water, when chemically analyzed, is either acid, sand, silt, clay and fine organic matter out of water. neutral or base (alkaline). To measure this, the water You can see sediments in water by filling a clear is given a pH value between 0 and 14. Water is acid drinking glass. When held up to light, you can see the if the pH is from 0 to 6.9. At 7, the water is neutral, and particles floating in the water, or settled to the bottom above that the water is alkaline. of the glass. The filter is filled with "filter aggregate" mineral that traps and holds the sediments as the Your Sears neutralizing filter treats acid water when water flows through it. the pH is from 6.0 to 6.7. A Sears Cartridge Filter with a Phosphate Crystal Cartridge is often used to treat The Clarifier is sometimes installed alone, but is often water with a pH of 6.8 to 6.9. Acid water shortens the followed by a water softener. Besides softening the life of iron pipe, corrodes copper and brass pipe, and water, the water softener catches sediments that makes green stains on plumbing fixtures. In time, it may get through the filter. will even etch porcelain enamel. The filter has a special mineral (Neutralite) that raises the pH of the NOTE: water to help reduce these acid water problems. If you will install the clarifying filter along with a Sears Solution Dispensing System, read the dispensing system owners manual for treating a private well before installing. TASTE & ODOR FILTER A Sears taste & odor filter removes most tastes, odors and certain organic colors from water. Bad tastes and odors come from many different causes. Often, one causes the other. The activated carbon bed, in the taste & odor filter, has a great ability for taking tastes and odors out of water. NOTE: If your water has hydrogen sulfide (rotten egg taste or odor), be sure to get a qualified testing laboratories recommendation for proper treatment. 11 SECTION 2 YOURFILTER HOWWATERWORKS II 20. FILTERED WATER SERVICE, AND BACKWASH SERVICE CLARIFIER FILTER During service (FIG. 5) water goes into the filter and DOWN through the bed of mineral. The mineral takes the dirt, sand, silt, clay and other sediments out of the water and holds it in the bed. Clear, clean water goes out of the filter and into the house pipes. NEUTRALIZER FILTER As low pH (acid) water flows DOWN through the filter, neutralite mineral is slowly dissolved to raise the pH. The neutralized or non-acid water then flows into the house water pipes. Because the neutralite does dissolv...

Herunterladen

Geben Sie zwei Ziffern: