Coverage Do not overtighten the screw. . Set the amount of TIME you want the lights to stay on after motion is detected (1, 5, or 20 minutes). . Set the DUALBRITE® switch to the amount of time after dusk you want the lights on at low level (Off, 3, 6 Hrs., Dusk-to-Dawn). NOTE: DUALZONE™ is a new zone of detection which wasaddedasanoptiontoselectHeath®/Zenithmotion sensing products. This feature adds a zone of detection under the motion sensor. DUALZONE™ requires no additional adjustment and oper

. Replace the rubber cover to protect controls. Aim Sensor Out for Long Coverage Expected Coverage The sensor is less sensitive to motion directly When mounted 8 feet (2.4 m) from the ground, towards it, most sensitive to motion across its field you may expect the range shown below. If of view. mounted much higher the sensor may miss objects near the ground. If mounted much lower the 70 ft. 100 ft. Least Sensitive Most Sensitive (21 m) (30,5 m) (Boosted) Sensor Maximum Range sensor range may be

120 VAC, 60 Hz Operating Modes . . . . TEST, AUTO, and MANUAL MODE Time Delay . . . . . . . . 1, 5, 10 minutes Range . . . . . . . . . . . . Adjustable DESA Specialty Products™ reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold. . Loosen the clamp screw in the sensor ball joint and gently rotate the sensor. . Walk through the coverage area noting where you are when the lights

• If you want to use Manual Mode, the control must be wired through a switch. • Some codes require installation by a qualified electrician. • This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations. • Note: This product is not recommended for use where the outside temperature is below -10° F. OPERATION Mode: On-Time: Works: Day Night Test 5 Sec x x Auto 1, 5, 10 min. x Manual Until Dawn* x * resets to Auto Mode at dawn. Note: When first t

595-5575-06 3 TROUBLESHOOTING GUIDE SYMPTOM POSSIBLE CAUSE Lights will 1. Light switch is turned off. not come on. 2. Light is loose or burned out. 3. Fuse is blown or circuit breaker is turned off. 4. Daylight turn-off is in effect (Recheck after dark). 5. Incorrect circuit wiring, if this is a new installation. 6. Re-aim the sensor to cover desired area. Lights come 1. Light Control may be installed in a on in day-relatively dark location. light. 2. Light Control is in Test. (Set control switc