• Make sure the tray contains a CD. • Make sure the CD’s label is facing up. • Make sure that pause mode is not activated. • Make sure CD function is selected. • Clean the CD (as explained in “CARE AND MAINTENANCE”). • Check CD for warping, scratches, or other damage. • Check for vibration or shock that may affect the unit; move system if necessary. • Inspect the recording head and clean it if necessary. • Demagnetize recording head (as explained in “CARE AND MAINTENANCE”). System doesn’t turn o

Insert a cassette tape into the tape deck and close the door. 2. Move FUNCTION to CD. 3. Insert the CD you want to record into CD compartment. 4. Select the track you want to record by pressing (skip/search) or (skip/search). 5. Press REC to start recording. Note that the tape continues to run when the CD finishes playing, or the CD continues to play when the tape reaches the end. TIP Using the PAUSE button on the cassette deck instead of the STOP/EJECT button to momentarily interrupt recording

BATTERY POWER Insert 6 D-sized dry batteries (not supplied) and you can take your system just about anywhere. Open the battery compartment door on the back of the unit by pressing down the two tabs and pulling out the cover. Insert batteries as marked on the back. Important Battery Information • If you are not going to use your system for a month or more, be sure to remove batteries because they can leak and cause damage. • Dispose of batteries in the proper manner, according to federal, state,

n If you drop the camera kit or it is damaged, disconnect the AC adapter immediately. •Refer servicing to the nearest JVC dealer. •Do NOT continue using the camera kit if it is damaged; otherwise, this can result in a risk of fire or electric shock. •NEVER attempt to repair the camera kit by yourself, otherwise serious/fatal injury may result. n If water or foreign objects enter the camera kit, disconnect the AC adapter immediately. •Refer servicing to the nearest JVC dealer. •Do NOT continue us

If a desirable metal brace position is not possible, attach the provided spacer around the bolt projecting from the metal brace. 3. ATTACH THE METAL BRACE Select a section of ceiling which is made of material which will enable screws to be securely tightened. Place the metal brace on the ceiling so that the bolt projecting from it is positioned in the direction opposite of the camera lens. Align the screw* with the hole located on the metal brace, and screw it into the ceiling. Repeat for al

Zunähst die Gitterblende vom Grillrahmen abnehmen. Dann die 4 am Lautsprecher und Grillrahmen befindlichen Schraubenö- fnungen auf die Schraubenöfnungen an der Heckablage ausrlchten und die Schrauben und Muttern festziehen. Anschließend die Gitterblende am Grillrahmen anbrlngen (Abb. 2) 7. Bei gleicher Anbringung der Lautsprecher, jedoch ohne Verwendung des Grills, wie in Abb. 3 und 4 gezeigt vorgehen. 8. Die Anbringung der Lautsprecher an den Sei-ten-verkleidungen der hinteren Dachstreben ent