Bystanders should be encouraged to wear eye protection. If you are approached, stop the unit immediately. • Only for use on attachment-capable, gas-powered trimmers that have the On/Off Stop control located on the grip. On/Off Stop Control (located on grip) RULES FOR SAFE OPERATION • The TBBC is specifically approved for use with the following models of attachment-capable trimmers: Ryobi: Troy-Bilt: 775R TB20CS 750R TB25CS 790R TB25ET 890R TB70SS TB75SS Yard Man: TB90BC YM25 TB425CS YM75 TB475SS

WARNING: Before inspecting, cleaning, or servicing the machine, shut off engine, wait for all moving parts to stop, and disconnect spark plug wire and move it away from spark plug. Failure to follow these instructions can result in serious personal injury or property damage. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust,

If “L” low needle can not be turned anticlockwise, do not force plastic limiter caps. Contact a servicing dealer. See Figure 25. Engine does not reach full speed and emits excessive smoke: 1. Check oil fuel mixture. 2. Air filter dirty. 3. Carburettor requires adjustment. 1. Use fresh fuel and the correct 2-cycle oil mix. 2. Clean air filter. Refer to “Replacing and Cleaning Air Filter” earlier in this manual. 3. Turn “H” needle clockwise 1/16 - 1/8 turn. See Figure25. Engine starts, runs, and a

Install the spool retainer and turn anticlockwise to tighten securely. BLADE GUARD BLADE CUPPED WASHER BLADE NUT HOLDING PIN Fig. 10 SPANNER (13 mm) UPPER FLANGE WASHER GEAR HEAD 11 OPERATION OPERATION FUEL AND REFUELLING HANDLING THE FUEL SAFELY ¦ ¦¦¦¦¦Always handle fuel with care. It is highly flammable. ¦ ¦¦¦¦¦Always refuel outdoors where there are no sparks and flames. Do not inhale fuel vapour. ¦ ¦¦¦¦¦Do not let petrol or oil come in contact with your skin. ¦ ¦¦¦¦¦Keep petrol and oil away f

. n Maintain a proper grip on the unit whenever the engine is running. Use your right hand to firmly grip the rear handle while your left hand has a firm grip on the front handle. . n Hold unit firmly with both hands. Always keep your left hand on the front handle and your right hand on the rear handle, so your body is to the left of the chain line. Never use a left-handed (cross-handed) grip, or any stance that places your body or arm across the chain line. . n Never stand directly under the li

WARNINg: Do not use any attachments or accessories not recom- mended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. WARNINg: To avoid kickback, binding of the saw bar, and possible injury, never cut limbs that the pruner does not reach when supported by the shoulder strap. APPLICATIONS You may use this product for the purposes listed below: • Limbing • Pruning PREPARATION FOR CUTTINg See Figures 5 - 6. • Wear non-

Le agradecemos su compra. CONSERVER CE MANUEL POUR FUTURE REFERENCE GUARDE ESTE MANUAL PARA FUTURAS CONSULTAS ii See this fold-out section for all of the figures referenced in the operator’s manual. Consulter l’encart a volets afin d’examiner toutes les figures mentionnees dans le manuel d’utilisation. Consulte esta seccion desplegable para ver todas las figuras a las que se hace referencia en el manual del operador. Fig. 1 Fig. 2 K RY52604/ RY52907 J F E D I L B C H C A G B A A N O D E M F P A

When properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product. Thank you for your purchase. TABLE OF CONTENTS • Introduction ..................................................................................................................................................................... . • General Safety Rules.........................................

Cut from side of tree opposite branch you are cutting. ... Do not cut from a ladder; this is extremely dangerous. Leave this operation for professionals. ... Do not to make the flush cut next to the main limb or trunk until you have cut off the limb further out to reduce the weight. Following proper cutting procedures will prevent stripping the bark from the main member. ... Do not use the pruner for felling or bucking. ... To prevent electrocution, do not operate within 50 ft. of overhead elect

RY52004A The model number will be found on a plate attached to the engine housing. Always mention the model number in all correspondence regarding your GAS PRUNER or when ordering replacement parts. KEY PART NO. NUMBER 1 82589 2 985382001 3 PS06258 4 PS06259 5 PS01718 6 986174001 7 985384003 8 PS05266 9 985835001 10 PS02155 11 944701 12 985744001 13 82496 14 82278 15 00422 16 84004 17 81242 18 83009 19 A08130 20 07255 21 09207 22 PS02764 23 PS02227 24 985157001 25 983