3) While tightening the blade assembly can be held fast by inserting a wrench or the screwdriver supplied into the cap and gearcase holes; to do this, rotate the cap until the two holes align. NB. Only use blades or nylon string heads marked with a maximum speed of at least 10.500 min-1. For instructions to replace the nylon string please refer to illustrations N1-5 in the front of this manual. G. ENGINE/SHAFT ASSEMBLY A DANGER. Do not run engine without shaft attached as clutch could fly off. 1

A blade with worn teeth besides providing poor performance might also generate a sudden thrust. This can result in a violent sideways kick caused when the blade touches against wood or solid bodies, such thrust might then cause the operator to loose control of the machine itself. Never attempt to work with a damaged blade but replace it with a new one. THRUST: can occur when using any type of circular blade within the risk area: therefore it is advisable to cut using the remaining area of the bl

• Be sure tiller is on level surface. • Oil will drain more freely when warm. • Catch oil in a suitable container. • Remove drain plug. • Tip tiller forward to drain oil. • After oil has drained completely, replace oil drain plug and tighten securely. • Remove oil filler plug. Be careful not to allow dirt to enter the engine. • Refill engine with oil. See “CHECK ENGINE OIL LEVEL” in the Operation section of this manual. engine_art_12 OIL DRAIN PLUG OIL FILLER PLUG OIL LEVEL .....................

USE CLEAN FILL FUNNELS. FILL ENGINE WITH OIL (See Fig. 7) • With engine level, remove engine oil filler plug. • Fill engine with oil to point of overflowing. For ap proxi mate ca pac i ty see “PRODUCT SPEC I FI CATIONS” on page 3 of this manual. • Tilt tiller back on its wheels and then re-level. • With engine level, refill to point of overflowing if neces sary. Re place oil filler plug. • For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Main

Double insulated -No Serviceable Parts Inside. 2. To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider then the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. 3. With a basic understanding of kickback, you can reduce or eliminate the element of surprise. S

THE USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF A WARRANTY CLAIM. Blades Keep blades sharp and check blade condition frequently. If a blade’s performance changes suddenly, stop the engine and check the blade for cracks or other damage. Replace a damaged blade IMMEDIATELY! Daily Maintenance WARNING! Before performing any maintenance, repair or cleaning wo

Always wear eye and hearing protection when operating this unit. Part Number 81359 Rev 8/06 Attention Statements Introduction Safety Instructions Throughout this manual are special “attention statements”. The Shindaiwa 242 Series hand held power equipment has been designed and built to deliver superior performance and reliability without compromise to quality, comfort, safety or durability. Shindaiwa engines represent the leading edge of high-performance engine technology, delivering exceptional

As the engine owner, you should however be aware that Shindaiwa Corporation may deny your warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications. You are responsible for presenting your engine to the nearest dealer authorized by Shindaiwa Corporation when a problem exists. If your Shindaiwa Dealer is unable to answer questions regarding your warranty rights and responsibilities, you should then contact your Shindaiwa Distribu