& CANADA MODEL ONLY CAUTION TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE CAREFULLY INSERTED TO PREVENT BLADE EXPOSURE WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS MEDIA PLAYER TO WATER OR MOISTURE CAUTION: USE OF CONTROLS OR ADJUSTMENTS OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE THE MEDIA PLAYER SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT PROPERLY QU

After pressing one of the FLASH BUTTONS (6), the corresponding Flash Button LED will flash briefly. The LED will remain lit indicating either a sample or cue point is stored in memory. The red Memory Cue LED will now shut off. Figure 17 Figure 18 2) Repeat the above steps to store up to three Cue Points. Once all your three cue points have been stored you may access them at any time. The cue points will instantly start without any music interruption. Please note in order to access these cue p

Disc Type: Standard compact discs (5 in / 12 cm and 3 in / 8 cm discs) Dimensions: Player Unit: 19” (W) x 3 27/64” (H) x 9 28/32” (D) 482mm (W) x 88.8mm (H) x 251mm (D)(without feet) Control Unit: 19” (W) x 3 27/64” (H) x 2 23/43" (D) 482mm (W) x 88.8mm (H) x 60mm (D) (without feet) Installation: 19-inch rack mountable - Player & Control units: 2U / 2 rack spaces Weight: Player Unit: 11 lbs. / 5 kg. - Control Unit: 4.5 lbs. / 2kg. Power Supply: 115/230V AC, 50/60 Hz Power Consumption: 25W Enviro

Turntables should only be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and the white represents the left channel input. Input volume will be controlled by channel three Channel Fader (9). The channel Source Selector Switch (5) must be in the "Line 3" position, to monitor any source connected to these jacks. 43. CHANNEL 3: PHONO 3 INPUT/AUX 3 JACKS - The type of input must directly refl ect the selected mode of the Line Level Selector Switch (5). Connec

10 Thank you for purchasing this American DJ® product. The Q-2221/X Is ready to be used, there Is no assembly required. Please read the following Instructions before installing or using your new unit. The Q-2221/X has a 2 year limited warranty! CAUTION! - Keep this device away from rain and moisture! Safety Instructions Always plug in the power last. Make sure that the Power switch is set to the OFF position before connecting other devices to the mixer. Keep away from heaters and other heat

Also, check that all cables are connected to the right connectors; it does matter which way the inputs and outputs are connected. 3. If DMX connectors are fairly short, ordinary microphone cables ©American DJ Supply® -- DJ Scan 250HP™ User Manual Page 11 may be used. For longer runs, this may cause data transmission problems (which will show up as random or incorrect movements) for best result, use proper balanced data transmission cable. Unit does not respond to sound; 1. Be sure the audio sens

Slide the I-beam connector into the I-beam tube. Slide the other connector into the other tube. (See Fig. 1) 2. Insert the connector knob through the I-beam and the connector and fasten with wing nut. Do the same for other connector knob. (See Fig. 2) 3. Now take two of the slide mount T-collar and attach to either end of the center support bar. (See Fig. 3) 4. Slide the center support bar assembly onto the I-beam with attached connectors. (See Fig. 4) 5. Take the other 5’ I-beam (the side w

American DJ ® hereby warrants, to the American DJ ® products to befree of manufacturing defects Year (365 days) from the date of purchase. This warranty shall be valid only within the United States of America, including possessions responsibility to establish the date thetime service is sought. B. For warranty service, send the product only American DJ ® factory. All shipping charges must be pre-paid. If the requested repairs are within the terms of this warranty, American DJ ® will pay return s

Due to physical specifications, a great piece for mobile DJ’s, roller rinks, small clubs, When used in multiples of two that rivals that of units that can cost The DJ Scan/RG™ was designed to run in with any universal DMX-512 controller. Customer Support: American DJ ® provides a toll free customer support line, to provide set-up and installation help question should you encounter problems during operation. You may also visit us on the web at for any comments or suggestions. Toll free customer s

Every Aquarius II™ has shipped in perfect operating carton for damage that appears to be damaged, carefully be sure all equipment necessary In the event damage has been contact our toll free customer support Please do not return the unit to your contacting customer support Unpacking: Every Aquarius II™ has been thoroughly tested and been shipped in perfect operating condition. Carefully carton for damage that may have occurred during the carton appears to be damaged, carefully inspect damage and