Stimmen - 3, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
Slide the I-beam connector into the I-beam tube. Slide the other connector into the other tube. (See Fig. 1) 2. Insert the connector knob through the I-beam and the connector and fasten with wing nut. Do the same for other connector knob. (See Fig. 2) 3. Now take two of the slide mount T-collar and attach to either end of the center support bar. (See Fig. 3) 4. Slide the center support bar assembly onto the I-beam with attached connectors. (See Fig. 4) 5. Take the other 5’ I-beam (the side with the vertical support rod) and slide it over the beam connector inside the center support bar assembly’s T-collars. (See Fig. 5) 6. With the both I-beams in place, insert the remaining two knobs into the other 5’ I-beam and fasten with wing nut. (See Fig. 6) 7. On the T-collars above and below the center support bar, tighten the small knobs so the full truss is secure. (See Fig. 7) 8. Set up the two Tri-pod stands. Adjust the telescopic adjustment assemblies by loosening the knobs to preferred height. Slide two T-collars each onto the Tri-pod center posts. Move the truss assembly into the T-collars. Then place another T-collar on the very top of each Tri-pod’s center post. (See Fig.8) 9. Tighten the small knobs on the T-collars on the Tri-pod center posts at each end of the truss. Slide a T-bar into each of the top T-collars on the Tri-pod posts. (See Fig. 9) 10. Fasten bolts and wing nuts into T-bar. Finish by tightening the small knobs on the T-collar. (See Fig. 10) 11. Reposition if needed, recheck all connectors, and tighten all fastners before mounting any fixtures to your completed LTS-50T trussing system. Specifications: Model LTS-50T TM Weight: 42 lbs. System Capacity: 200 lbs. Affordable Quality Lighting Products from American DJ® Los Angeles, CA 90058 5 FT. I-BEAM Z-LTS-I/C Z-LTS-T Z-LTS/SB fig. 3 w Z-LTS-T c o o PERPENDICULAR SUPPORT ROD Z-LTS-I/C IE Z-LTS-I/KNOB fig.5 Z-LTS-I/KNOB flg. б Z-LTS2/SK Z-LTS-T Z-LTS2 /SK ^ Z-1.0/M6B d Z-1.0/M6 Z-LTS2 /SK ^ Z-1.0/M6B ® Z-1.0/M6 Z-LTS2/TEL-ADJ TRI-POD CENTER POST Z-LTS/LL-ADAPTOR Z-LTS2/LK TRI-POD STAND flg. 9...