Stimmen - 5, Durchschnittliche Bewertung: 4.4
(
)
)
|
Anleitung Zusammenfassung
Tighten screws. See Figure 23. Glass Door Installation Continued Spring Clip Bottom Door Rail Ash Box Center Brick Figure 23 - Adjusting Bi-Fold Doors Screws Operation and Maintenance Guidelines Glass Doors Glass doors are optional with the fireplace. When fireplace is in operation, doors must be fully opened or fully closed position only or a fire hazard may be created (see Figure 24). A fireplace equipped with glass doors operates much differently than a fireplace with an open front. A fireplace with glass doors has a limited amount of air for combustion. Excessive heat within the fireplace can result if too large a fire is built or if combustion air gate is not completely open. The following tips should be followed to assure that both the fireplace and glass door retain their beauty and function properly. Both the flue damper and glass doors must be fully opened before starting fire. This will provide sufficient combustion air and maintain safe temperatures in firebox. Ring Handle Figure 21 - Installing Bottom Door Rail Fold Door and Slide Top Pins Into Track Spring Clip Insert Pin into Spring Clip Doors Fully Closed Fireplace Front Insert Bottom Pivot Pin into Hole Fireplace Front Doors Fully Opened Pivot Hole Figure 22 - Installing Bi-Fold Doors Figure 24 - Bi-Fold Glass Doors IMPORTANT: The glass must be allowed to warm slowly and evenly. The tempered glass will withstand a gradual temperature rise to 550° F, which is more than a normal fire will generate. Such materials as pitch/wax laden logs, very dry mill end lumber and large amounts of paper or cardboard boxes can create an excessively hot fire and should not be burned in this fireplace. Always keep the fire well back from the doors and never allow flames to contact the glass. WARNING: Fireplaces equipped with glass doors should be operated only with doors fully opened or doors fully closed. Doors, if left partly open, may draw gas and flame out of the fireplace opening creating risks of both fire and smoke. Cleaning Glass Clean glass with any commercial glass cleaner or soap and water. Do not use any abrasive material to clean glass. Do not clean glass with any cool water if glass is still hot from the fire and smoke. A gas line or gas log lighter may be installed for the purpose of installing a vented or vent-free decorative gas appliance incorporating an automatic shutoff device and complying with the Standard for Decorative Gas Appliances for Installation in Vented Fireplaces, ANSI Z21.60 or American Gas Association draft requirements for Gas Fired Log Lighters for Wood Burning Fireplaces, Draft NO. 4 dated August, 1993. If you wish to install an unvented (vent-free) gas log set, only unvented gas log sets which have been found to comply with the standard for unvented room heaters, ANSI Z21.11.2 are to be installed in this fireplace. outside air and damper handle operation The damper handle, which opens and closes the damper blade, is located in the upper front face of the fireplace. Pushing the handle forward and up through the keyway slot will free damper blade to automatically open. Pushing the handle forward and down will lock damper blade closed (see Figure 25). The outside air kit lever is located at the left and right hand sides of fireplace (see Figure 26). Lifting lever up will free the outside air door to open. Pulling lever down will lock the door. WARNING: Risk of fire! Replace grate with DESA model 109496-03 grate only. This grate has been designed to keep the operation of your fireplace safe and efficient. Operation and maintenance Guidelines Continued Damper Weight To Close Damper Damper Weight To Open Damper Figure 25 - Operating Damper Handle Open Position Closed Position Figure 26 - Outside Air Kit Lever Technical Service You may have further questions about installation, operation, or troubleshooting. If so, contact DESA’s Technical Service Department at 1-866-672-6040. When calling please have your model and serial numbers of your heater ready. You can also visit DESA’s technical services web site at Replacement Parts Herringbone Brick Liner Bottom Front Brick Refractory 116092-01 - VG36H Models 116092-02 - G36H Models Bottom Rear Brick Refractory 116089-01 - VG36H Models 116089-02 - G36H Models Right Brick Refractory 116087-01 - VG36H Models 116087-02 - G36H Models Left Brick Refractory 116086-01 - VG36H Models 116086-02 - G36H Models Rear Brick Refractory 116088-01 - VG36H Models 116088-02 - G36H Models StandarD Brick Liner Bottom Front Brick Refractory 116091-01 - VG36 Models 116091-02 - G36 Models Bottom Rear Brick Refractory 116084-01 - VG36 Models 116084-02 - G36 Models Right Brick Refractory 116082-01 - VG36 Models 116082-02 - G36 Models Left Brick Refractory 116081-01 - VG36 Models 116081-02 - G36 Models Rear Brick Refractory 116083-01 - VG36 Models 116083-02 - G36 Models Grate 109496-03 - Model GM36 Series Ember Protector - EP36 Ash Box - 111498-01 Accessories Bi-Fold Glass Door BDG36 - 36" Black...
Dieses Handbuch ist für folgende Modelle:Kamine - (V)G36 (1.09 mb)
Kamine - (V)G36HR (1.09 mb)
Kamine - (V)G36R (1.09 mb)