Stimmen - 2, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: Stovax Dateigröße: 2.16 mb Dateiname: Unterrichtssprache:

Homeowner must contact a qualified service technician at once if any abnormal condition is observed. If the venting system is disassembled for any reason, a qualified service technician should follow vent installation instructions for proper reassembly and proper sealing of the venting system components. However, more frequent periodic inspections and cleanings should be performed by the homeowner. Cleaning Glass (Also see Front Glass Enclosure Panel, Removal and Installation on Page 11). Note: Clean glass after first two weeks of operation (after Burn-In period is over) and then only when necessary and only when the fireplace is cool. Wipe surface with clean, dampened, soft cloth. Follow with dry, soft towel as desired. Take care not to scratch the glass surface. Clean the viewing glass periodically to remove any build-up caused from the following: IMPORTANT: Do not use abrasive cleaners on glass. Never clean the glass when it is hot. • During start-up, it is normal for condensation to form on the inside of the glass (this condensation and fog will usually disappear in a few minutes). The moisture can cause lint, dust and other airborne particles to cling to the glass surface. • Initial curing of the high temperature paint and burning off of lubricants used in the manufacturing process may result in a film on the glass. • A white coating may form on the glass as a result of impurities and minerals in the fuel. It is recommended that the glass be cleaned two or three times during each heating season, depending on the circumstances present. The following cleaning solutions are approved for use to clean glass: • Non-ammonia based household cleaner • 50%-50% mix of white vinegar and water • Gas fireplace/stove glass cleaner Inspect Glass Gasket Visually inspect the gasket on the backside of the glass enclosure panels. The gasket surface must be clean, free of irregularities and seated firmly. Clean Control Compartment Keep control compartment clean by vacuuming or brushing at least twice a year. More frequent cleaning may be required due to excessive lint from carpeting, bedding materials, etc. It is important that control compartments, burners and circulating air passageways of the appliance be kept clean. Clean Logs And Burner Carefully remove the logs (use care when handling the fiber logs, as they become quite fragile after curing). Vacuum out any foreign matter (lint, carbon, etc.) on the burner. Ensure the burner ports are “open.” Remove any carbon deposits from the under side of the logs using a vacuum cleaner, or a soft bristled brush (i.e. paint brush). Note: Improper positioning of logs can create carbon build-up and will alter the performance of the appliance. Replacing Logs If the logs become damaged by accident or improper handling and need replacement, use only the proper replacement logs from manufacturer (see Pages 13,14 and 15 for ordering information). Re-Install Embers and Logs Carefully follow placement instructions on Pages 12 t...

Herunterladen

Geben Sie zwei Ziffern: